Commit 0a0b7a5f authored by Kurt Van Dijck's avatar Kurt Van Dijck Committed by David S. Miller

can: add driver for Softing card

This patch adds the driver that creates a platform:softing device
from a pcmcia_device
Note: the Kconfig indicates a dependency on the softing.ko driver,
but this is purely to make configuration intuitive. This driver will
work independent, but no CAN network devices appear until softing.ko is
loaded too.
Signed-off-by: default avatarKurt Van Dijck <kurt.van.dijck@eia.be>
Acked-by: default avatarWolfgang Grandegger <wg@grandegger.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 03fd3cf5
...@@ -14,3 +14,17 @@ config CAN_SOFTING ...@@ -14,3 +14,17 @@ config CAN_SOFTING
controls the 2 busses on the card together. controls the 2 busses on the card together.
As such, some actions (start/stop/busoff recovery) on 1 bus As such, some actions (start/stop/busoff recovery) on 1 bus
must bring down the other bus too temporarily. must bring down the other bus too temporarily.
config CAN_SOFTING_CS
tristate "Softing Gmbh CAN pcmcia cards"
depends on PCMCIA
select CAN_SOFTING
---help---
Support for PCMCIA cards from Softing Gmbh & some cards
from Vector Gmbh.
You need firmware for these, which you can get at
http://developer.berlios.de/projects/socketcan/
This version of the driver is written against
firmware version 4.6 (softing-fw-4.6-binaries.tar.gz)
In order to use the card as CAN device, you need the Softing generic
support too.
softing-y := softing_main.o softing_fw.o softing-y := softing_main.o softing_fw.o
obj-$(CONFIG_CAN_SOFTING) += softing.o obj-$(CONFIG_CAN_SOFTING) += softing.o
obj-$(CONFIG_CAN_SOFTING_CS) += softing_cs.o
ccflags-$(CONFIG_CAN_DEBUG_DEVICES) := -DDEBUG ccflags-$(CONFIG_CAN_DEBUG_DEVICES) := -DDEBUG
This diff is collapsed.
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment