ath10k: allow empty ssid vdev config

It doesn't make much sense to reject a valid
firmware configuration combination.

Since SSID isn't known early on it might make
sense to allow driver to start vdev without SSID
and restart it later.
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath10k/wmi-tlv.c

@@ -1518,8 +1518,6 @@ ath10k_wmi_tlv_op_gen_vdev_start(struct ath10k *ar,
 	void *ptr;
 	u32 flags = 0;
 
-	if (WARN_ON(arg->ssid && arg->ssid_len == 0))
-		return ERR_PTR(-EINVAL);
 	if (WARN_ON(arg->hidden_ssid && !arg->ssid))
 		return ERR_PTR(-EINVAL);
 	if (WARN_ON(arg->ssid_len > sizeof(cmd->ssid.ssid)))

drivers/net/wireless/ath/ath10k/wmi.c

@@ -4248,8 +4248,6 @@ ath10k_wmi_op_gen_vdev_start(struct ath10k *ar,
 	const char *cmdname;
 	u32 flags = 0;
 
-	if (WARN_ON(arg->ssid && arg->ssid_len == 0))
-		return ERR_PTR(-EINVAL);
 	if (WARN_ON(arg->hidden_ssid && !arg->ssid))
 		return ERR_PTR(-EINVAL);
 	if (WARN_ON(arg->ssid_len > sizeof(cmd->ssid.ssid)))