Commit 0ae9fdef authored by Richard Genoud's avatar Richard Genoud Committed by Greg Kroah-Hartman

BUG: atmel_serial: Interrupts not disabled on close

Since commit 18dfef9c ("serial: atmel: convert to irq handling
provided mctrl-gpio"), interrupts from GPIOs are not disabled any more
when the serial port is closed, leading to an oops when the one of the
input pin is toggled (CTS/DSR/DCD/RNG).

This is only the case if those pins are used as GPIOs, i.e. declared
like that:
usart1: serial@f8020000 {
        /* CTS and DTS will be handled by GPIO */
        status = "okay";
        rts-gpios = <&pioB 17 GPIO_ACTIVE_LOW>;
        cts-gpios = <&pioB 16 GPIO_ACTIVE_LOW>;
        dtr-gpios = <&pioB 14 GPIO_ACTIVE_LOW>;
        dsr-gpios = <&pioC 31 GPIO_ACTIVE_LOW>;
        rng-gpios = <&pioB 12 GPIO_ACTIVE_LOW>;
        dcd-gpios = <&pioB 15 GPIO_ACTIVE_LOW>;
};

That's because modem interrupts used to be freed in atmel_shutdown().
After commit 18dfef9c ("serial: atmel: convert to irq handling
provided mctrl-gpio"), this code was just removed.
Calling atmel_disable_ms() disables the interrupts and everything works
fine again.

Tested on at91sam9g35-cm

(This patch doesn't apply on -stable kernels, fixes for 4.4 and 4.7 will
be sent after this one is applied.)
Signed-off-by: default avatarRichard Genoud <richard.genoud@gmail.com>
Fixes: 18dfef9c ("serial: atmel: convert to irq handling provided mctrl-gpio")
Acked-by: default avatarNicolas Ferre <nicolas.ferre@atmel.com>
Acked-by: default avatarUwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 33ddca08
......@@ -1937,6 +1937,9 @@ static void atmel_shutdown(struct uart_port *port)
{
struct atmel_uart_port *atmel_port = to_atmel_uart_port(port);
/* Disable modem control lines interrupts */
atmel_disable_ms(port);
/* Disable interrupts at device level */
atmel_uart_writel(port, ATMEL_US_IDR, -1);
......@@ -1987,8 +1990,6 @@ static void atmel_shutdown(struct uart_port *port)
*/
free_irq(port->irq, port);
atmel_port->ms_irq_enabled = false;
atmel_flush_buffer(port);
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment