Commit 0af0467f authored by Juuso Oikarinen's avatar Juuso Oikarinen Committed by Luciano Coelho

wl12xx: Fix potential incorrect band in rx-status

The rx-status passed to mac80211 along with each received frame contains the
band on which the frame was received. Under certain circumstances, this band
information may be incorrect, causing in worst case a WARNING from mac80211,
and causes the received frame to be dropped.

This scenario mainly occurs when performing connected-mode scans, when the
received scan results are from the other band than the one currently
associated to.

[Since desc_band doesn't exist anymore, use status->band in the later
call to ieee80211_channel_to_frequency() to fix compilation -- Luca]
Signed-off-by: default avatarJuuso Oikarinen <juuso.oikarinen@nokia.com>
Reviewed-by: default avatarLuciano Coelho <coelho@ti.com>
Signed-off-by: default avatarLuciano Coelho <coelho@ti.com>
parent e7ddf549
......@@ -48,18 +48,14 @@ static void wl1271_rx_status(struct wl1271 *wl,
struct ieee80211_rx_status *status,
u8 beacon)
{
enum ieee80211_band desc_band;
memset(status, 0, sizeof(struct ieee80211_rx_status));
status->band = wl->band;
if ((desc->flags & WL1271_RX_DESC_BAND_MASK) == WL1271_RX_DESC_BAND_BG)
desc_band = IEEE80211_BAND_2GHZ;
status->band = IEEE80211_BAND_2GHZ;
else
desc_band = IEEE80211_BAND_5GHZ;
status->band = IEEE80211_BAND_5GHZ;
status->rate_idx = wl1271_rate_to_idx(desc->rate, desc_band);
status->rate_idx = wl1271_rate_to_idx(desc->rate, status->band);
#ifdef CONFIG_WL12XX_HT
/* 11n support */
......@@ -76,7 +72,8 @@ static void wl1271_rx_status(struct wl1271 *wl,
*/
wl->noise = desc->rssi - (desc->snr >> 1);
status->freq = ieee80211_channel_to_frequency(desc->channel, desc_band);
status->freq = ieee80211_channel_to_frequency(desc->channel,
status->band);
if (desc->flags & WL1271_RX_DESC_ENCRYPT_MASK) {
status->flag |= RX_FLAG_IV_STRIPPED | RX_FLAG_MMIC_STRIPPED;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment