USB: ehci: fix some ehci hangs and crashes

I noticed that the "Refactor "if (handshake()) state = HC_STATE_HALT"
patch from earlier this year perpetuated a potential problem:  it can
mark the controller as halted when it's still running (but not acting
as, perhaps wrongly, expected).

That caused some hangs and crashes, rather than more polite failure
modes of a truly halted controller.  This patch forces a true halt,
and emits a (previously missing) diagnostic.
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

drivers/usb/host/ehci-hcd.c

@@ -145,16 +145,6 @@ static int handshake (struct ehci_hcd *ehci, void __iomem *ptr,
 	return -ETIMEDOUT;
 }
 
-static int handshake_on_error_set_halt(struct ehci_hcd *ehci, void __iomem *ptr,
-				       u32 mask, u32 done, int usec)
-{
-	int error = handshake(ehci, ptr, mask, done, usec);
-	if (error)
-		ehci_to_hcd(ehci)->state = HC_STATE_HALT;
-
-	return error;
-}
-
 /* force HC to halt state from unknown (EHCI spec section 2.3) */
 static int ehci_halt (struct ehci_hcd *ehci)
 {
@@ -173,6 +163,22 @@ static int ehci_halt (struct ehci_hcd *ehci)
 			  STS_HALT, STS_HALT, 16 * 125);
 }
 
+static int handshake_on_error_set_halt(struct ehci_hcd *ehci, void __iomem *ptr,
+				       u32 mask, u32 done, int usec)
+{
+	int error;
+
+	error = handshake(ehci, ptr, mask, done, usec);
+	if (error) {
+		ehci_halt(ehci);
+		ehci_to_hcd(ehci)->state = HC_STATE_HALT;
+		ehci_err(ehci, "force halt; handhake %p %08x %08x -> %d\n",
+			ptr, mask, done, error);
+	}
+
+	return error;
+}
+
 /* put TDI/ARC silicon into EHCI mode */
 static void tdi_reset (struct ehci_hcd *ehci)
 {