thermal: rcar: fix ENR register value

On R-Mobile APE6, since it has 3 thermal zones, ENR register
has enable bits in bit 19-16, bit 11-8 and bit 3-0.

However, on R-Car gen2, since it has 1 thermal zone, ENR register has
enable bits in bit 3-0. (In other words, the write value should always
be 0 for bit 31-4 of ENR register.)

So, this patch fixes the ENR register value using I/O resource sets.
Acked-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Signed-off-by: Eduardo Valentin <edubezval@gmail.com>

drivers/thermal/rcar_thermal.c

@@ -372,6 +372,7 @@ static int rcar_thermal_probe(struct platform_device *pdev)
 	int i;
 	int ret = -ENODEV;
 	int idle = IDLE_INTERVAL;
+	u32 enr_bits = 0;
 
 	common = devm_kzalloc(dev, sizeof(*common), GFP_KERNEL);
 	if (!common)
@@ -408,9 +409,6 @@ static int rcar_thermal_probe(struct platform_device *pdev)
 		if (IS_ERR(common->base))
 			return PTR_ERR(common->base);
 
-		/* enable temperature comparation */
-		rcar_thermal_common_write(common, ENR, 0x00030303);
-
 		idle = 0; /* polling delay is not needed */
 	}
 
@@ -452,8 +450,15 @@ static int rcar_thermal_probe(struct platform_device *pdev)
 			rcar_thermal_irq_enable(priv);
 
 		list_move_tail(&priv->list, &common->head);
+
+		/* update ENR bits */
+		enr_bits |= 3 << (i * 8);
 	}
 
+	/* enable temperature comparation */
+	if (irq)
+		rcar_thermal_common_write(common, ENR, enr_bits);
+
 	platform_set_drvdata(pdev, common);
 
 	dev_info(dev, "%d sensor probed\n", i);