USB: iowarrior.c: timeouts too small in usb_control_msg calls

The driver uses usb_control_msg() for exchanging data with the device.
When the driver lived freeley _outside_ the kernel tree (pre 2.6.21) the
timeouts for these calls where set to 5*HZ for reading, 1HZ for writing.
(These timeouts seemed to work fine for all users of the driver, at
least nobody complained in the last 2 years.

The current code (2.6.21-rc5) removed the 'HZ' from the timeouts and
left the driver with 5 jiffies for reading and 1 jiffy for writing. My
new machine is fast, but not that fast.

The patch also removes a useless debug statement, which was left over
from testing a broken firmware version

From: Eberhard Fahle <e.fahle@wayoda.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

drivers/usb/misc/iowarrior.c

@@ -118,7 +118,7 @@ static int usb_get_report(struct usb_device *dev,
 			       USB_DIR_IN | USB_TYPE_CLASS |
 			       USB_RECIP_INTERFACE, (type << 8) + id,
 			       inter->desc.bInterfaceNumber, buf, size,
-			       GET_TIMEOUT);
+			       GET_TIMEOUT*HZ);
 }
 //#endif
 
@@ -133,7 +133,7 @@ static int usb_set_report(struct usb_interface *intf, unsigned char type,
 			       USB_TYPE_CLASS | USB_RECIP_INTERFACE,
 			       (type << 8) + id,
 			       intf->cur_altsetting->desc.bInterfaceNumber, buf,
-			       size, 1);
+			       size, HZ);
 }
 
 /*---------------------*/
@@ -750,7 +750,6 @@ static int iowarrior_probe(struct usb_interface *interface,
 	struct usb_endpoint_descriptor *endpoint;
 	int i;
 	int retval = -ENOMEM;
-	int idele = 0;
 
 	/* allocate memory for our device state and intialize it */
 	dev = kzalloc(sizeof(struct iowarrior), GFP_KERNEL);
@@ -826,11 +825,10 @@ static int iowarrior_probe(struct usb_interface *interface,
 
 	/* Set the idle timeout to 0, if this is interface 0 */
 	if (dev->interface->cur_altsetting->desc.bInterfaceNumber == 0) {
-		idele = usb_control_msg(udev, usb_sndctrlpipe(udev, 0),
-					0x0A,
-					USB_TYPE_CLASS | USB_RECIP_INTERFACE, 0,
-					0, NULL, 0, USB_CTRL_SET_TIMEOUT);
-		dbg("idele = %d", idele);
+	    usb_control_msg(udev, usb_sndctrlpipe(udev, 0),
+			    0x0A,
+			    USB_TYPE_CLASS | USB_RECIP_INTERFACE, 0,
+			    0, NULL, 0, USB_CTRL_SET_TIMEOUT);
 	}
 	/* allow device read and ioctl */
 	dev->present = 1;