Commit 14faea9f authored by bo yang's avatar bo yang Committed by James Bottomley

[SCSI] megaraid_sas: check max_sgl reported by FW for setting max_sectors_per_req

1. Setting the max_sectors_per_req based on max SGL supported by the
   FW. Prior versions calculated this value from controller info's
   max_sectors_1, max_sectors_2. For certain controllers/FW, this was
   resulting in a value greater than max SGL supported by the FW. Now
   we take the min of max sgl from FW and max_sectors calculation.

2. Increased MFI_POLL_TIMEOUT_SECS to 60 seconds from 10. FW may take
   a max of 60 seconds to respond to the INIT cmd.
Signed-off-by: default avatarBo Yang <bo.yang@lsi.com>
Signed-off-by: default avatarJames Bottomley <James.Bottomley@HansenPartnership.com>
parent 31ea7088
......@@ -1890,6 +1890,7 @@ static int megasas_init_mfi(struct megasas_instance *instance)
u32 reply_q_sz;
u32 max_sectors_1;
u32 max_sectors_2;
u32 tmp_sectors;
struct megasas_register_set __iomem *reg_set;
struct megasas_ctrl_info *ctrl_info;
/*
......@@ -1982,17 +1983,20 @@ static int megasas_init_mfi(struct megasas_instance *instance)
* Note that older firmwares ( < FW ver 30) didn't report information
* to calculate max_sectors_1. So the number ended up as zero always.
*/
tmp_sectors = 0;
if (ctrl_info && !megasas_get_ctrl_info(instance, ctrl_info)) {
max_sectors_1 = (1 << ctrl_info->stripe_sz_ops.min) *
ctrl_info->max_strips_per_io;
max_sectors_2 = ctrl_info->max_request_size;
instance->max_sectors_per_req = (max_sectors_1 < max_sectors_2)
? max_sectors_1 : max_sectors_2;
} else
instance->max_sectors_per_req = instance->max_num_sge *
PAGE_SIZE / 512;
tmp_sectors = min_t(u32, max_sectors_1 , max_sectors_2);
}
instance->max_sectors_per_req = instance->max_num_sge *
PAGE_SIZE / 512;
if (tmp_sectors && (instance->max_sectors_per_req > tmp_sectors))
instance->max_sectors_per_req = tmp_sectors;
kfree(ctrl_info);
......
......@@ -571,7 +571,7 @@ struct megasas_ctrl_info {
#define IS_DMA64 (sizeof(dma_addr_t) == 8)
#define MFI_OB_INTR_STATUS_MASK 0x00000002
#define MFI_POLL_TIMEOUT_SECS 10
#define MFI_POLL_TIMEOUT_SECS 60
#define MFI_REPLY_1078_MESSAGE_INTERRUPT 0x80000000
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment