arm64: dts: mediatek: asurada: Enable MMC

Enable both MMC controllers present on Asurada. MMC0 is for
non-removable internal memory, while MMC1 is an SD card slot. MMC1 isn't
used on all machines, but in those cases the CD interrupt is never
triggered and thus it is basically as if it was disabled.
Signed-off-by: Nícolas F. R. A. Prado <nfraprado@collabora.com>
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Tested-by: Chen-Yu Tsai <wenst@chromium.org>
Link: https://lore.kernel.org/r/20220629155956.1138955-18-nfraprado@collabora.comSigned-off-by: Matthias Brugger <matthias.bgg@gmail.com>

arch/arm64/boot/dts/mediatek/mt8192-asurada.dtsi

@@ -170,6 +170,46 @@ &i2c7 {
 	pinctrl-0 = <&i2c7_pins>;
 };
 
+&mmc0 {
+	status = "okay";
+
+	pinctrl-names = "default", "state_uhs";
+	pinctrl-0 = <&mmc0_default_pins>;
+	pinctrl-1 = <&mmc0_uhs_pins>;
+	bus-width = <8>;
+	max-frequency = <200000000>;
+	vmmc-supply = <&mt6359_vemc_1_ldo_reg>;
+	vqmmc-supply = <&mt6359_vufs_ldo_reg>;
+	cap-mmc-highspeed;
+	mmc-hs200-1_8v;
+	mmc-hs400-1_8v;
+	supports-cqe;
+	cap-mmc-hw-reset;
+	mmc-hs400-enhanced-strobe;
+	hs400-ds-delay = <0x12814>;
+	no-sdio;
+	no-sd;
+	non-removable;
+};
+
+&mmc1 {
+	status = "okay";
+
+	pinctrl-names = "default", "state_uhs";
+	pinctrl-0 = <&mmc1_default_pins>;
+	pinctrl-1 = <&mmc1_uhs_pins>;
+	bus-width = <4>;
+	max-frequency = <200000000>;
+	cd-gpios = <&pio 17 GPIO_ACTIVE_LOW>;
+	vmmc-supply = <&mt6360_ldo5_reg>;
+	vqmmc-supply = <&mt6360_ldo3_reg>;
+	cap-sd-highspeed;
+	sd-uhs-sdr50;
+	sd-uhs-sdr104;
+	no-sdio;
+	no-mmc;
+};
+
 /* for CORE */
 &mt6359_vgpu11_buck_reg {
 	regulator-always-on;
@@ -503,6 +543,115 @@ pins-bus {
 		};
 	};
 
+	mmc0_default_pins: mmc0-default-pins {
+		pins-cmd-dat {
+			pinmux = <PINMUX_GPIO184__FUNC_MSDC0_DAT0>,
+				 <PINMUX_GPIO188__FUNC_MSDC0_DAT1>,
+				 <PINMUX_GPIO185__FUNC_MSDC0_DAT2>,
+				 <PINMUX_GPIO193__FUNC_MSDC0_DAT3>,
+				 <PINMUX_GPIO186__FUNC_MSDC0_DAT4>,
+				 <PINMUX_GPIO189__FUNC_MSDC0_DAT5>,
+				 <PINMUX_GPIO187__FUNC_MSDC0_DAT6>,
+				 <PINMUX_GPIO190__FUNC_MSDC0_DAT7>,
+				 <PINMUX_GPIO183__FUNC_MSDC0_CMD>;
+			input-enable;
+			drive-strength = <8>;
+			bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
+		};
+
+		pins-clk {
+			pinmux = <PINMUX_GPIO192__FUNC_MSDC0_CLK>;
+			drive-strength = <8>;
+			bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
+		};
+
+		pins-rst {
+			pinmux = <PINMUX_GPIO194__FUNC_MSDC0_RSTB>;
+			drive-strength = <8>;
+			bias-pull-down = <MTK_PUPD_SET_R1R0_01>;
+		};
+	};
+
+	mmc0_uhs_pins: mmc0-uhs-pins {
+		pins-cmd-dat {
+			pinmux = <PINMUX_GPIO184__FUNC_MSDC0_DAT0>,
+				 <PINMUX_GPIO188__FUNC_MSDC0_DAT1>,
+				 <PINMUX_GPIO185__FUNC_MSDC0_DAT2>,
+				 <PINMUX_GPIO193__FUNC_MSDC0_DAT3>,
+				 <PINMUX_GPIO186__FUNC_MSDC0_DAT4>,
+				 <PINMUX_GPIO189__FUNC_MSDC0_DAT5>,
+				 <PINMUX_GPIO187__FUNC_MSDC0_DAT6>,
+				 <PINMUX_GPIO190__FUNC_MSDC0_DAT7>,
+				 <PINMUX_GPIO183__FUNC_MSDC0_CMD>;
+			input-enable;
+			drive-strength = <10>;
+			bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
+		};
+
+		pins-clk {
+			pinmux = <PINMUX_GPIO192__FUNC_MSDC0_CLK>;
+			drive-strength = <10>;
+			bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
+		};
+
+		pins-rst {
+			pinmux = <PINMUX_GPIO194__FUNC_MSDC0_RSTB>;
+			drive-strength = <8>;
+			bias-pull-down = <MTK_PUPD_SET_R1R0_01>;
+		};
+
+		pins-ds {
+			pinmux = <PINMUX_GPIO191__FUNC_MSDC0_DSL>;
+			drive-strength = <10>;
+			bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
+		};
+	};
+
+	mmc1_default_pins: mmc1-default-pins {
+		pins-cmd-dat {
+			pinmux = <PINMUX_GPIO54__FUNC_MSDC1_DAT0>,
+				 <PINMUX_GPIO56__FUNC_MSDC1_DAT1>,
+				 <PINMUX_GPIO55__FUNC_MSDC1_DAT2>,
+				 <PINMUX_GPIO53__FUNC_MSDC1_DAT3>,
+				 <PINMUX_GPIO52__FUNC_MSDC1_CMD>;
+			input-enable;
+			drive-strength = <8>;
+			bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
+		};
+
+		pins-clk {
+			pinmux = <PINMUX_GPIO51__FUNC_MSDC1_CLK>;
+			drive-strength = <8>;
+			bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
+		};
+
+		pins-insert {
+			pinmux = <PINMUX_GPIO17__FUNC_GPIO17>;
+			input-enable;
+			bias-pull-up;
+		};
+	};
+
+	mmc1_uhs_pins: mmc1-uhs-pins {
+		pins-cmd-dat {
+			pinmux = <PINMUX_GPIO54__FUNC_MSDC1_DAT0>,
+				 <PINMUX_GPIO56__FUNC_MSDC1_DAT1>,
+				 <PINMUX_GPIO55__FUNC_MSDC1_DAT2>,
+				 <PINMUX_GPIO53__FUNC_MSDC1_DAT3>,
+				 <PINMUX_GPIO52__FUNC_MSDC1_CMD>;
+			input-enable;
+			drive-strength = <8>;
+			bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
+		};
+
+		pins-clk {
+			pinmux = <PINMUX_GPIO51__FUNC_MSDC1_CLK>;
+			input-enable;
+			drive-strength = <8>;
+			bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
+		};
+	};
+
 	pcie_pins: pcie-default-pins {
 		pins-pcie-wake {
 			pinmux = <PINMUX_GPIO63__FUNC_PCIE_WAKE_N>;