Commit 17269568 authored by Taniya Das's avatar Taniya Das Committed by Stephen Boyd

clk: qcom: Add Global Clock controller (GCC) driver for SC7180

Add support for the global clock controller found on SC7180
based devices. This should allow most non-multimedia device
drivers to probe and control their clocks.
Signed-off-by: default avatarTaniya Das <tdas@codeaurora.org>
Link: https://lkml.kernel.org/r/20191014102308.27441-6-tdas@codeaurora.orgSigned-off-by: default avatarStephen Boyd <sboyd@kernel.org>
parent 8b9e0562
...@@ -227,6 +227,15 @@ config QCS_GCC_404 ...@@ -227,6 +227,15 @@ config QCS_GCC_404
Say Y if you want to use multimedia devices or peripheral Say Y if you want to use multimedia devices or peripheral
devices such as UART, SPI, I2C, USB, SD/eMMC, PCIe etc. devices such as UART, SPI, I2C, USB, SD/eMMC, PCIe etc.
config SC_GCC_7180
tristate "SC7180 Global Clock Controller"
select QCOM_GDSC
depends on COMMON_CLK_QCOM
help
Support for the global clock controller on SC7180 devices.
Say Y if you want to use peripheral devices such as UART, SPI,
I2C, USB, UFS, SDCC, etc.
config SDM_CAMCC_845 config SDM_CAMCC_845
tristate "SDM845 Camera Clock Controller" tristate "SDM845 Camera Clock Controller"
select SDM_GCC_845 select SDM_GCC_845
......
...@@ -44,6 +44,7 @@ obj-$(CONFIG_QCOM_CLK_SMD_RPM) += clk-smd-rpm.o ...@@ -44,6 +44,7 @@ obj-$(CONFIG_QCOM_CLK_SMD_RPM) += clk-smd-rpm.o
obj-$(CONFIG_QCS_GCC_404) += gcc-qcs404.o obj-$(CONFIG_QCS_GCC_404) += gcc-qcs404.o
obj-$(CONFIG_QCS_Q6SSTOP_404) += q6sstop-qcs404.o obj-$(CONFIG_QCS_Q6SSTOP_404) += q6sstop-qcs404.o
obj-$(CONFIG_QCS_TURING_404) += turingcc-qcs404.o obj-$(CONFIG_QCS_TURING_404) += turingcc-qcs404.o
obj-$(CONFIG_SC_GCC_7180) += gcc-sc7180.o
obj-$(CONFIG_SDM_CAMCC_845) += camcc-sdm845.o obj-$(CONFIG_SDM_CAMCC_845) += camcc-sdm845.o
obj-$(CONFIG_SDM_DISPCC_845) += dispcc-sdm845.o obj-$(CONFIG_SDM_DISPCC_845) += dispcc-sdm845.o
obj-$(CONFIG_SDM_GCC_660) += gcc-sdm660.o obj-$(CONFIG_SDM_GCC_660) += gcc-sdm660.o
......
This diff is collapsed.
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment