spi: spi-geni-qcom: Simplify setup_fifo_xfer()

The definition of SPI_FULL_DUPLEX (3) is really SPI_TX_ONLY (1) ORed
with SPI_RX_ONLY (2). Let's drop the define and simplify the code here a
bit by collapsing the setting of 'm_cmd' into conditions that are the
same.

This is a non-functional change, just cleanup to consolidate code.
Signed-off-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Douglas Anderson <dianders@chromium.org>
Link: https://lore.kernel.org/r/20200620022233.64716-2-swboyd@chromium.orgSigned-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi-geni-qcom.c

@@ -51,7 +51,6 @@
 /* M_CMD OP codes for SPI */
 #define SPI_TX_ONLY		1
 #define SPI_RX_ONLY		2
-#define SPI_FULL_DUPLEX		3
 #define SPI_TX_RX		7
 #define SPI_CS_ASSERT		8
 #define SPI_CS_DEASSERT		9
@@ -353,12 +352,6 @@ static void setup_fifo_xfer(struct spi_transfer *xfer,
 
 	mas->tx_rem_bytes = 0;
 	mas->rx_rem_bytes = 0;
-	if (xfer->tx_buf && xfer->rx_buf)
-		m_cmd = SPI_FULL_DUPLEX;
-	else if (xfer->tx_buf)
-		m_cmd = SPI_TX_ONLY;
-	else if (xfer->rx_buf)
-		m_cmd = SPI_RX_ONLY;
 
 	spi_tx_cfg &= ~CS_TOGGLE;
 
@@ -369,12 +362,14 @@ static void setup_fifo_xfer(struct spi_transfer *xfer,
 	len &= TRANS_LEN_MSK;
 
 	mas->cur_xfer = xfer;
-	if (m_cmd & SPI_TX_ONLY) {
+	if (xfer->tx_buf) {
+		m_cmd |= SPI_TX_ONLY;
 		mas->tx_rem_bytes = xfer->len;
 		writel(len, se->base + SE_SPI_TX_TRANS_LEN);
 	}
 
-	if (m_cmd & SPI_RX_ONLY) {
+	if (xfer->rx_buf) {
+		m_cmd |= SPI_RX_ONLY;
 		writel(len, se->base + SE_SPI_RX_TRANS_LEN);
 		mas->rx_rem_bytes = xfer->len;
 	}