habanalabs/gaudi: clear QM errors only if not in stop_on_err mode

Clearing QM errors by the driver will prevent these H/W blocks from
stopping in case they are configured to stop on errors, so perform this
clearing only if this mode is not in use.
Signed-off-by: Tomer Tayar <ttayar@habana.ai>
Reviewed-by: Oded Gabbay <ogabbay@kernel.org>
Signed-off-by: Oded Gabbay <ogabbay@kernel.org>

drivers/misc/habanalabs/gaudi/gaudi.c

@@ -7086,7 +7086,8 @@ static void gaudi_handle_qman_err_generic(struct hl_device *hdev,
 		}
 
 		/* Write 1 clear errors */
-		WREG32(glbl_sts_addr + 4 * i, glbl_sts_clr_val);
+		if (!hdev->stop_on_err)
+			WREG32(glbl_sts_addr + 4 * i, glbl_sts_clr_val);
 	}
 
 	arb_err_val = RREG32(arb_err_addr);