Commit 1b68480b authored by Philippe Schenker's avatar Philippe Schenker Committed by David S. Miller

ARM: dts: apalis-imx6qdl: use rgmii-id instead of rgmii

Until now a PHY-fixup in mach-imx set our rgmii timing correctly. For
the PHY KSZ9131 there is no PHY-fixup in mach-imx. To support this PHY
too, use rgmii-id.
For the now used KSZ9031 nothing will change, as rgmii-id is only
implemented and supported by the KSZ9131.
Signed-off-by: default avatarPhilippe Schenker <philippe.schenker@toradex.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent bd734a74
...@@ -180,7 +180,7 @@ &ecspi2 { ...@@ -180,7 +180,7 @@ &ecspi2 {
&fec { &fec {
pinctrl-names = "default"; pinctrl-names = "default";
pinctrl-0 = <&pinctrl_enet>; pinctrl-0 = <&pinctrl_enet>;
phy-mode = "rgmii"; phy-mode = "rgmii-id";
phy-handle = <&ethphy>; phy-handle = <&ethphy>;
phy-reset-duration = <10>; phy-reset-duration = <10>;
phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>; phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment