Commit 1c500840 authored by Olof Johansson's avatar Olof Johansson Committed by Jonathan Cameron

iio: accel: bmc150: reset chip at init time

In at least one known setup, the chip comes up in a state where reading
the chip ID returns garbage unless it's been reset, due to noise on the
wires during system boot.

All supported chips have the same reset method, and based on the
datasheets they all need 1.3 or 1.8ms to recover after reset. So, do
the conservative thing here and always reset the chip.
Signed-off-by: default avatarOlof Johansson <olof@lixom.net>
Reviewed-by: default avatarSrinivas Pandruvada <srinivas.pandruvada@linux.intel.com>
Cc: <Stable@vger.kernel.org>
Signed-off-by: default avatarJonathan Cameron <jic23@kernel.org>
parent 36afb176
...@@ -67,6 +67,9 @@ ...@@ -67,6 +67,9 @@
#define BMC150_ACCEL_REG_PMU_BW 0x10 #define BMC150_ACCEL_REG_PMU_BW 0x10
#define BMC150_ACCEL_DEF_BW 125 #define BMC150_ACCEL_DEF_BW 125
#define BMC150_ACCEL_REG_RESET 0x14
#define BMC150_ACCEL_RESET_VAL 0xB6
#define BMC150_ACCEL_REG_INT_MAP_0 0x19 #define BMC150_ACCEL_REG_INT_MAP_0 0x19
#define BMC150_ACCEL_INT_MAP_0_BIT_SLOPE BIT(2) #define BMC150_ACCEL_INT_MAP_0_BIT_SLOPE BIT(2)
...@@ -1497,6 +1500,14 @@ static int bmc150_accel_chip_init(struct bmc150_accel_data *data) ...@@ -1497,6 +1500,14 @@ static int bmc150_accel_chip_init(struct bmc150_accel_data *data)
int ret, i; int ret, i;
unsigned int val; unsigned int val;
/*
* Reset chip to get it in a known good state. A delay of 1.8ms after
* reset is required according to the data sheets of supported chips.
*/
regmap_write(data->regmap, BMC150_ACCEL_REG_RESET,
BMC150_ACCEL_RESET_VAL);
usleep_range(1800, 2500);
ret = regmap_read(data->regmap, BMC150_ACCEL_REG_CHIP_ID, &val); ret = regmap_read(data->regmap, BMC150_ACCEL_REG_CHIP_ID, &val);
if (ret < 0) { if (ret < 0) {
dev_err(dev, "Error: Reading chip id\n"); dev_err(dev, "Error: Reading chip id\n");
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment