Commit 203773e3 authored by Shengjiu Wang's avatar Shengjiu Wang Committed by Mark Brown

ASoC: fsl_esai: Don't use devm_regmap_init_mmio_clk

When there is power domain bind with bus clock,

The call flow:
devm_regmap_init_mmio_clk
    - clk_prepare()
       - clk_pm_runtime_get()

cause the power domain of clock always be enabled after
regmap_init(). which impact the power consumption.

So use devm_regmap_init_mmio instead of
devm_regmap_init_mmio_clk,but explicitly enable
clock when it is used.
Signed-off-by: default avatarShengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1616579928-22428-2-git-send-email-shengjiu.wang@nxp.comSigned-off-by: default avatarMark Brown <broonie@kernel.org>
parent f89c0a87
......@@ -945,6 +945,9 @@ static const struct regmap_config fsl_esai_regmap_config = {
.cache_type = REGCACHE_FLAT,
};
static int fsl_esai_runtime_resume(struct device *dev);
static int fsl_esai_runtime_suspend(struct device *dev);
static int fsl_esai_probe(struct platform_device *pdev)
{
struct device_node *np = pdev->dev.of_node;
......@@ -969,8 +972,7 @@ static int fsl_esai_probe(struct platform_device *pdev)
if (IS_ERR(regs))
return PTR_ERR(regs);
esai_priv->regmap = devm_regmap_init_mmio_clk(&pdev->dev,
"core", regs, &fsl_esai_regmap_config);
esai_priv->regmap = devm_regmap_init_mmio(&pdev->dev, regs, &fsl_esai_regmap_config);
if (IS_ERR(esai_priv->regmap)) {
dev_err(&pdev->dev, "failed to init regmap: %ld\n",
PTR_ERR(esai_priv->regmap));
......@@ -1039,11 +1041,23 @@ static int fsl_esai_probe(struct platform_device *pdev)
}
dev_set_drvdata(&pdev->dev, esai_priv);
spin_lock_init(&esai_priv->lock);
pm_runtime_enable(&pdev->dev);
if (!pm_runtime_enabled(&pdev->dev)) {
ret = fsl_esai_runtime_resume(&pdev->dev);
if (ret)
goto err_pm_disable;
}
ret = pm_runtime_get_sync(&pdev->dev);
if (ret < 0) {
pm_runtime_put_noidle(&pdev->dev);
goto err_pm_get_sync;
}
ret = fsl_esai_hw_init(esai_priv);
if (ret)
return ret;
goto err_pm_get_sync;
esai_priv->tx_mask = 0xFFFFFFFF;
esai_priv->rx_mask = 0xFFFFFFFF;
......@@ -1054,24 +1068,33 @@ static int fsl_esai_probe(struct platform_device *pdev)
regmap_write(esai_priv->regmap, REG_ESAI_RSMA, 0);
regmap_write(esai_priv->regmap, REG_ESAI_RSMB, 0);
ret = pm_runtime_put_sync(&pdev->dev);
if (ret < 0)
goto err_pm_get_sync;
ret = devm_snd_soc_register_component(&pdev->dev, &fsl_esai_component,
&fsl_esai_dai, 1);
if (ret) {
dev_err(&pdev->dev, "failed to register DAI: %d\n", ret);
return ret;
goto err_pm_get_sync;
}
INIT_WORK(&esai_priv->work, fsl_esai_hw_reset);
pm_runtime_enable(&pdev->dev);
regcache_cache_only(esai_priv->regmap, true);
ret = imx_pcm_dma_init(pdev, IMX_ESAI_DMABUF_SIZE);
if (ret)
if (ret) {
dev_err(&pdev->dev, "failed to init imx pcm dma: %d\n", ret);
goto err_pm_get_sync;
}
return ret;
err_pm_get_sync:
if (!pm_runtime_status_suspended(&pdev->dev))
fsl_esai_runtime_suspend(&pdev->dev);
err_pm_disable:
pm_runtime_disable(&pdev->dev);
return ret;
}
static int fsl_esai_remove(struct platform_device *pdev)
......@@ -1079,6 +1102,9 @@ static int fsl_esai_remove(struct platform_device *pdev)
struct fsl_esai *esai_priv = platform_get_drvdata(pdev);
pm_runtime_disable(&pdev->dev);
if (!pm_runtime_status_suspended(&pdev->dev))
fsl_esai_runtime_suspend(&pdev->dev);
cancel_work_sync(&esai_priv->work);
return 0;
......@@ -1092,7 +1118,6 @@ static const struct of_device_id fsl_esai_dt_ids[] = {
};
MODULE_DEVICE_TABLE(of, fsl_esai_dt_ids);
#ifdef CONFIG_PM
static int fsl_esai_runtime_resume(struct device *dev)
{
struct fsl_esai *esai = dev_get_drvdata(dev);
......@@ -1160,7 +1185,6 @@ static int fsl_esai_runtime_suspend(struct device *dev)
return 0;
}
#endif /* CONFIG_PM */
static const struct dev_pm_ops fsl_esai_pm_ops = {
SET_RUNTIME_PM_OPS(fsl_esai_runtime_suspend,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment