Commit 209c3aa7 authored by Adam Borowski's avatar Adam Borowski Committed by Jonathan Corbet

Documentation: sysrq: don't recommend 'S' 'U' before 'B'

This advice is obsolete and slightly harmful for filesystems from this
millenium: any modern filesystem can handle unexpected crashes without
requiring fsck -- and on the other hand, trying to write to the disk when
the kernel is in a bad state risks introducing corruption.

For ext2, any unsafe shutdown meant widespread breakage, but it's no longer
a reasonable filesystem for any non-special use.
Signed-off-by: default avatarAdam Borowski <kilobyte@angband.pl>
Signed-off-by: default avatarJonathan Corbet <corbet@lwn.net>
parent c193a3ff
......@@ -171,22 +171,20 @@ It seems others find it useful as (System Attention Key) which is
useful when you want to exit a program that will not let you switch consoles.
(For example, X or a svgalib program.)
``reboot(b)`` is good when you're unable to shut down. But you should also
``sync(s)`` and ``umount(u)`` first.
``reboot(b)`` is good when you're unable to shut down, it is an equivalent
of pressing the "reset" button.
``crash(c)`` can be used to manually trigger a crashdump when the system is hung.
Note that this just triggers a crash if there is no dump mechanism available.
``sync(s)`` is great when your system is locked up, it allows you to sync your
disks and will certainly lessen the chance of data loss and fscking. Note
that the sync hasn't taken place until you see the "OK" and "Done" appear
on the screen. (If the kernel is really in strife, you may not ever get the
OK or Done message...)
``sync(s)`` is handy before yanking removable medium or after using a rescue
shell that provides no graceful shutdown -- it will ensure your data is
safely written to the disk. Note that the sync hasn't taken place until you see
the "OK" and "Done" appear on the screen.
``umount(u)`` is basically useful in the same ways as ``sync(s)``. I generally
``sync(s)``, ``umount(u)``, then ``reboot(b)`` when my system locks. It's saved
me many a fsck. Again, the unmount (remount read-only) hasn't taken place until
you see the "OK" and "Done" message appear on the screen.
``umount(u)`` can be used to mark filesystems as properly unmounted. From the
running system's point of view, they will be remounted read-only. The remount
isn't complete until you see the "OK" and "Done" message appear on the screen.
The loglevels ``0``-``9`` are useful when your console is being flooded with
kernel messages you do not want to see. Selecting ``0`` will prevent all but
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment