ath10k: skip suspending when recovering

It doesn't make much sense to even try suspending
the device when recovering. Recovering means the
device is unresponsive and waiting for suspend
procedure means taking a 3 second timeout waiting
for tx credits.

This speeds up firmware recovery significantly.
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath10k/core.c

@@ -680,8 +680,8 @@ static void ath10k_core_restart(struct work_struct *work)
 
 	switch (ar->state) {
 	case ATH10K_STATE_ON:
-		ath10k_halt(ar);
 		ar->state = ATH10K_STATE_RESTARTING;
+		ath10k_halt(ar);
 		ieee80211_restart_hw(ar->hw);
 		break;
 	case ATH10K_STATE_OFF:
@@ -908,7 +908,9 @@ void ath10k_core_stop(struct ath10k *ar)
 	lockdep_assert_held(&ar->conf_mutex);
 
 	/* try to suspend target */
-	ath10k_wait_for_suspend(ar, WMI_PDEV_SUSPEND_AND_DISABLE_INTR);
+	if (ar->state != ATH10K_STATE_RESTARTING)
+		ath10k_wait_for_suspend(ar, WMI_PDEV_SUSPEND_AND_DISABLE_INTR);
+
 	ath10k_debug_stop(ar);
 	ath10k_htc_stop(&ar->htc);
 	ath10k_htt_detach(&ar->htt);