Commit 2411a736 authored by John Crispin's avatar John Crispin Committed by Kishon Vijay Abraham I

phy: ralink-usb: add driver for Mediatek/Ralink

Add a driver to setup the USB phy on Mediatek/Ralink SoCs.
The driver sets up power and host mode, but also needs to
configure PHY registers for the MT7628 and MT7688.
Signed-off-by: default avatarJohn Crispin <john@phrozen.org>
Signed-off-by: default avatarHarvey Hunt <harvey.hunt@imgtec.com>
Signed-off-by: default avatarKishon Vijay Abraham I <kishon@ti.com>
parent 1cc81efe
......@@ -48,6 +48,7 @@ source "drivers/phy/marvell/Kconfig"
source "drivers/phy/mediatek/Kconfig"
source "drivers/phy/motorola/Kconfig"
source "drivers/phy/qualcomm/Kconfig"
source "drivers/phy/ralink/Kconfig"
source "drivers/phy/renesas/Kconfig"
source "drivers/phy/rockchip/Kconfig"
source "drivers/phy/samsung/Kconfig"
......
......@@ -18,6 +18,7 @@ obj-y += broadcom/ \
marvell/ \
motorola/ \
qualcomm/ \
ralink/ \
samsung/ \
st/ \
ti/
#
# PHY drivers for Ralink platforms.
#
config PHY_RALINK_USB
tristate "Ralink USB PHY driver"
depends on RALINK || COMPILE_TEST
select GENERIC_PHY
select MFD_SYSCON
help
This option enables support for the Ralink USB PHY found inside
RT3352, MT7620, MT7628 and MT7688.
obj-$(CONFIG_PHY_RALINK_USB) += phy-ralink-usb.o
/*
* Copyright (C) 2017 John Crispin <john@phrozen.org>
*
* Based on code from
* Allwinner Technology Co., Ltd. <www.allwinnertech.com>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*/
#include <linux/delay.h>
#include <linux/err.h>
#include <linux/io.h>
#include <linux/kernel.h>
#include <linux/mfd/syscon.h>
#include <linux/module.h>
#include <linux/mutex.h>
#include <linux/of_platform.h>
#include <linux/phy/phy.h>
#include <linux/platform_device.h>
#include <linux/regmap.h>
#include <linux/reset.h>
#define RT_SYSC_REG_SYSCFG1 0x014
#define RT_SYSC_REG_CLKCFG1 0x030
#define RT_SYSC_REG_USB_PHY_CFG 0x05c
#define OFS_U2_PHY_AC0 0x800
#define OFS_U2_PHY_AC1 0x804
#define OFS_U2_PHY_AC2 0x808
#define OFS_U2_PHY_ACR0 0x810
#define OFS_U2_PHY_ACR1 0x814
#define OFS_U2_PHY_ACR2 0x818
#define OFS_U2_PHY_ACR3 0x81C
#define OFS_U2_PHY_ACR4 0x820
#define OFS_U2_PHY_AMON0 0x824
#define OFS_U2_PHY_DCR0 0x860
#define OFS_U2_PHY_DCR1 0x864
#define OFS_U2_PHY_DTM0 0x868
#define OFS_U2_PHY_DTM1 0x86C
#define RT_RSTCTRL_UDEV BIT(25)
#define RT_RSTCTRL_UHST BIT(22)
#define RT_SYSCFG1_USB0_HOST_MODE BIT(10)
#define MT7620_CLKCFG1_UPHY0_CLK_EN BIT(25)
#define MT7620_CLKCFG1_UPHY1_CLK_EN BIT(22)
#define RT_CLKCFG1_UPHY1_CLK_EN BIT(20)
#define RT_CLKCFG1_UPHY0_CLK_EN BIT(18)
#define USB_PHY_UTMI_8B60M BIT(1)
#define UDEV_WAKEUP BIT(0)
struct ralink_usb_phy {
struct reset_control *rstdev;
struct reset_control *rsthost;
u32 clk;
struct phy *phy;
void __iomem *base;
struct regmap *sysctl;
};
static void u2_phy_w32(struct ralink_usb_phy *phy, u32 val, u32 reg)
{
writel(val, phy->base + reg);
}
static u32 u2_phy_r32(struct ralink_usb_phy *phy, u32 reg)
{
return readl(phy->base + reg);
}
static void ralink_usb_phy_init(struct ralink_usb_phy *phy)
{
u2_phy_r32(phy, OFS_U2_PHY_AC2);
u2_phy_r32(phy, OFS_U2_PHY_ACR0);
u2_phy_r32(phy, OFS_U2_PHY_DCR0);
u2_phy_w32(phy, 0x00ffff02, OFS_U2_PHY_DCR0);
u2_phy_r32(phy, OFS_U2_PHY_DCR0);
u2_phy_w32(phy, 0x00555502, OFS_U2_PHY_DCR0);
u2_phy_r32(phy, OFS_U2_PHY_DCR0);
u2_phy_w32(phy, 0x00aaaa02, OFS_U2_PHY_DCR0);
u2_phy_r32(phy, OFS_U2_PHY_DCR0);
u2_phy_w32(phy, 0x00000402, OFS_U2_PHY_DCR0);
u2_phy_r32(phy, OFS_U2_PHY_DCR0);
u2_phy_w32(phy, 0x0048086a, OFS_U2_PHY_AC0);
u2_phy_w32(phy, 0x4400001c, OFS_U2_PHY_AC1);
u2_phy_w32(phy, 0xc0200000, OFS_U2_PHY_ACR3);
u2_phy_w32(phy, 0x02000000, OFS_U2_PHY_DTM0);
}
static int ralink_usb_phy_power_on(struct phy *_phy)
{
struct ralink_usb_phy *phy = phy_get_drvdata(_phy);
u32 t;
/* enable the phy */
regmap_update_bits(phy->sysctl, RT_SYSC_REG_CLKCFG1,
phy->clk, phy->clk);
/* setup host mode */
regmap_update_bits(phy->sysctl, RT_SYSC_REG_SYSCFG1,
RT_SYSCFG1_USB0_HOST_MODE,
RT_SYSCFG1_USB0_HOST_MODE);
/* deassert the reset lines */
reset_control_deassert(phy->rsthost);
reset_control_deassert(phy->rstdev);
/*
* The SDK kernel had a delay of 100ms. however on device
* testing showed that 10ms is enough
*/
mdelay(10);
if (phy->base)
ralink_usb_phy_init(phy);
/* print some status info */
regmap_read(phy->sysctl, RT_SYSC_REG_USB_PHY_CFG, &t);
dev_info(&phy->phy->dev, "remote usb device wakeup %s\n",
(t & UDEV_WAKEUP) ? ("enabled") : ("disabled"));
if (t & USB_PHY_UTMI_8B60M)
dev_info(&phy->phy->dev, "UTMI 8bit 60MHz\n");
else
dev_info(&phy->phy->dev, "UTMI 16bit 30MHz\n");
return 0;
}
static int ralink_usb_phy_power_off(struct phy *_phy)
{
struct ralink_usb_phy *phy = phy_get_drvdata(_phy);
/* disable the phy */
regmap_update_bits(phy->sysctl, RT_SYSC_REG_CLKCFG1,
phy->clk, 0);
/* assert the reset lines */
reset_control_assert(phy->rstdev);
reset_control_assert(phy->rsthost);
return 0;
}
static struct phy_ops ralink_usb_phy_ops = {
.power_on = ralink_usb_phy_power_on,
.power_off = ralink_usb_phy_power_off,
.owner = THIS_MODULE,
};
static const struct of_device_id ralink_usb_phy_of_match[] = {
{
.compatible = "ralink,rt3352-usbphy",
.data = (void *) (RT_CLKCFG1_UPHY1_CLK_EN |
RT_CLKCFG1_UPHY0_CLK_EN)
},
{
.compatible = "mediatek,mt7620-usbphy",
.data = (void *) (MT7620_CLKCFG1_UPHY1_CLK_EN |
MT7620_CLKCFG1_UPHY0_CLK_EN)
},
{
.compatible = "mediatek,mt7628-usbphy",
.data = (void *) (MT7620_CLKCFG1_UPHY1_CLK_EN |
MT7620_CLKCFG1_UPHY0_CLK_EN) },
{ },
};
MODULE_DEVICE_TABLE(of, ralink_usb_phy_of_match);
static int ralink_usb_phy_probe(struct platform_device *pdev)
{
struct device *dev = &pdev->dev;
struct resource *res;
struct phy_provider *phy_provider;
const struct of_device_id *match;
struct ralink_usb_phy *phy;
match = of_match_device(ralink_usb_phy_of_match, &pdev->dev);
if (!match)
return -ENODEV;
phy = devm_kzalloc(dev, sizeof(*phy), GFP_KERNEL);
if (!phy)
return -ENOMEM;
phy->clk = (u32) match->data;
phy->base = NULL;
phy->sysctl = syscon_regmap_lookup_by_phandle(dev->of_node, "ralink,sysctl");
if (IS_ERR(phy->sysctl)) {
dev_err(dev, "failed to get sysctl registers\n");
return PTR_ERR(phy->sysctl);
}
/* The MT7628 and MT7688 require extra setup of PHY registers. */
if (of_device_is_compatible(dev->of_node, "mediatek,mt7628-usbphy")) {
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
phy->base = devm_ioremap_resource(&pdev->dev, res);
if (IS_ERR(phy->base)) {
dev_err(dev, "failed to remap register memory\n");
return PTR_ERR(phy->base);
}
}
phy->rsthost = devm_reset_control_get(&pdev->dev, "host");
if (IS_ERR(phy->rsthost)) {
dev_err(dev, "host reset is missing\n");
return PTR_ERR(phy->rsthost);
}
phy->rstdev = devm_reset_control_get(&pdev->dev, "device");
if (IS_ERR(phy->rstdev)) {
dev_err(dev, "device reset is missing\n");
return PTR_ERR(phy->rstdev);
}
phy->phy = devm_phy_create(dev, NULL, &ralink_usb_phy_ops);
if (IS_ERR(phy->phy)) {
dev_err(dev, "failed to create PHY\n");
return PTR_ERR(phy->phy);
}
phy_set_drvdata(phy->phy, phy);
phy_provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate);
return PTR_ERR_OR_ZERO(phy_provider);
}
static struct platform_driver ralink_usb_phy_driver = {
.probe = ralink_usb_phy_probe,
.driver = {
.of_match_table = ralink_usb_phy_of_match,
.name = "ralink-usb-phy",
}
};
module_platform_driver(ralink_usb_phy_driver);
MODULE_DESCRIPTION("Ralink USB phy driver");
MODULE_AUTHOR("John Crispin <john@phrozen.org>");
MODULE_LICENSE("GPL v2");
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment