Commit 24b923f0 authored by Mauro Carvalho Chehab's avatar Mauro Carvalho Chehab Committed by Mauro Carvalho Chehab

[media] cx231xx: fix GPIOs for Pixelview SBTVD hybrid

This device uses GPIOs: 28 to switch between analog and
digital modes: on digital mode, it should be set to 1.

The code that sets it on analog mode is OK, but it misses
the logic that sets it on digital mode.

Cc: stable@vger.kernel.org
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab@s-opensource.com>
parent 1871d718
......@@ -486,7 +486,7 @@ struct cx231xx_board cx231xx_boards[] = {
.output_mode = OUT_MODE_VIP11,
.demod_xfer_mode = 0,
.ctl_pin_status_mask = 0xFFFFFFC4,
.agc_analog_digital_select_gpio = 0x00, /* According with PV cxPolaris.inf file */
.agc_analog_digital_select_gpio = 0x1c,
.tuner_sif_gpio = -1,
.tuner_scl_gpio = -1,
.tuner_sda_gpio = -1,
......
......@@ -712,6 +712,7 @@ int cx231xx_set_mode(struct cx231xx *dev, enum cx231xx_mode set_mode)
break;
case CX231XX_BOARD_CNXT_RDE_253S:
case CX231XX_BOARD_CNXT_RDU_253S:
case CX231XX_BOARD_PV_PLAYTV_USB_HYBRID:
errCode = cx231xx_set_agc_analog_digital_mux_select(dev, 1);
break;
case CX231XX_BOARD_HAUPPAUGE_EXETER:
......@@ -738,7 +739,7 @@ int cx231xx_set_mode(struct cx231xx *dev, enum cx231xx_mode set_mode)
case CX231XX_BOARD_PV_PLAYTV_USB_HYBRID:
case CX231XX_BOARD_HAUPPAUGE_USB2_FM_PAL:
case CX231XX_BOARD_HAUPPAUGE_USB2_FM_NTSC:
errCode = cx231xx_set_agc_analog_digital_mux_select(dev, 0);
errCode = cx231xx_set_agc_analog_digital_mux_select(dev, 0);
break;
default:
break;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment