Skip to content

L
linux
Commit 254361c1 authored by Sebastian Sanchez's avatar Sebastian Sanchez Committed by Doug Ledford
Browse files
Options

IB/hfi1: Prevent LNI hang when LCB can't obtain lanes 

When the LCB isn't able to get any lanes operational on the
first transition into mission mode, the link transfer active
never happens and the LNI stays in the polling state indefinitely.

Reset LCB upon receiving an 8051 interrupt for LCB to try to obtain
lanes with firmware version 1.25.0 or later. Also, update the LCB
reset value in other parts of the code with a macro defined to make
the code more maintainable and rename functions with the link_width
label to link_mode to reflect the fact that those functions set and
read link related data not just the link width.
Reviewed-by: default avatarMichael J. Ruhl <michael.j.ruhl@intel.com>
Reviewed-by: default avatarMike Marciniszyn <mike.marciniszyn@intel.com>
Signed-off-by: default avatarSebastian Sanchez <sebastian.sanchez@intel.com>
Signed-off-by: default avatarDennis Dalessandro <dennis.dalessandro@intel.com>
Signed-off-by: default avatarDoug Ledford <dledford@redhat.com>
parent f5e27a20
Hide whitespace changes
Inline Side-by-side
Showing with 53 additions and 20 deletions
drivers/infiniband/hw/hfi1/chip.c
View file @ 254361c1
......@@ -1032,8 +1032,8 @@ static void read_vc_remote_fabric(struct hfi1_devdata *dd, u8 *vau, u8 *z,
u8 *vcu, u16 *vl15buf, u8 *crc_sizes);
static void read_vc_remote_link_width(struct hfi1_devdata *dd,
u8 *remote_tx_rate, u16 *link_widths);
static void read_vc_local_link_width(struct hfi1_devdata *dd, u8 *misc_bits,
u8 *flag_bits, u16 *link_widths);
static void read_vc_local_link_mode(struct hfi1_devdata *dd, u8 *misc_bits,
u8 *flag_bits, u16 *link_widths);
static void read_remote_device_id(struct hfi1_devdata *dd, u16 *device_id,
u8 *device_rev);
static void read_local_lni(struct hfi1_devdata *dd, u8 *enable_lane_rx);
......@@ -6350,6 +6350,18 @@ static void handle_8051_request(struct hfi1_pportdata *ppd)
dd_dev_info(dd, "8051 request: request 0x%x not supported\n",
type);
hreq_response(dd, HREQ_NOT_SUPPORTED, 0);
break;
case HREQ_LCB_RESET:
/* Put the LCB, RX FPE and TX FPE into reset */
write_csr(dd, DCC_CFG_RESET, LCB_RX_FPE_TX_FPE_INTO_RESET);
/* Make sure the write completed */
(void)read_csr(dd, DCC_CFG_RESET);
/* Hold the reset long enough to take effect */
udelay(1);
/* Take the LCB, RX FPE and TX FPE out of reset */
write_csr(dd, DCC_CFG_RESET, LCB_RX_FPE_TX_FPE_OUT_OF_RESET);
hreq_response(dd, HREQ_SUCCESS, 0);
break;
case HREQ_CONFIG_DONE:
hreq_response(dd, HREQ_SUCCESS, 0);
......@@ -6461,8 +6473,7 @@ static void lcb_shutdown(struct hfi1_devdata *dd, int abort)
dd->lcb_err_en = read_csr(dd, DC_LCB_ERR_EN);
reg = read_csr(dd, DCC_CFG_RESET);
write_csr(dd, DCC_CFG_RESET, reg |
(1ull << DCC_CFG_RESET_RESET_LCB_SHIFT) |
(1ull << DCC_CFG_RESET_RESET_RX_FPE_SHIFT));
DCC_CFG_RESET_RESET_LCB | DCC_CFG_RESET_RESET_RX_FPE);
(void)read_csr(dd, DCC_CFG_RESET); /* make sure the write completed */
if (!abort) {
udelay(1); /* must hold for the longer of 16cclks or 20ns */
......@@ -6527,7 +6538,7 @@ static void _dc_start(struct hfi1_devdata *dd)
__func__);
/* Take away reset for LCB and RX FPE (set in lcb_shutdown). */
write_csr(dd, DCC_CFG_RESET, 0x10);
write_csr(dd, DCC_CFG_RESET, LCB_RX_FPE_TX_FPE_OUT_OF_RESET);
/* lcb_shutdown() with abort=1 does not restore these */
write_csr(dd, DC_LCB_ERR_EN, dd->lcb_err_en);
dd->dc_shutdown = 0;
......@@ -7348,7 +7359,7 @@ static void get_linkup_widths(struct hfi1_devdata *dd, u16 *tx_width,
u8 misc_bits, local_flags;
u16 active_tx, active_rx;
read_vc_local_link_width(dd, &misc_bits, &local_flags, &widths);
read_vc_local_link_mode(dd, &misc_bits, &local_flags, &widths);
tx = widths >> 12;
rx = (widths >> 8) & 0xf;
......@@ -8820,29 +8831,29 @@ static int write_vc_local_fabric(struct hfi1_devdata *dd, u8 vau, u8 z, u8 vcu,
GENERAL_CONFIG, frame);
}
static void read_vc_local_link_width(struct hfi1_devdata *dd, u8 *misc_bits,
u8 *flag_bits, u16 *link_widths)
static void read_vc_local_link_mode(struct hfi1_devdata *dd, u8 *misc_bits,
u8 *flag_bits, u16 *link_widths)
{
u32 frame;
read_8051_config(dd, VERIFY_CAP_LOCAL_LINK_WIDTH, GENERAL_CONFIG,
read_8051_config(dd, VERIFY_CAP_LOCAL_LINK_MODE, GENERAL_CONFIG,
&frame);
*misc_bits = (frame >> MISC_CONFIG_BITS_SHIFT) & MISC_CONFIG_BITS_MASK;
*flag_bits = (frame >> LOCAL_FLAG_BITS_SHIFT) & LOCAL_FLAG_BITS_MASK;
*link_widths = (frame >> LINK_WIDTH_SHIFT) & LINK_WIDTH_MASK;
}
static int write_vc_local_link_width(struct hfi1_devdata *dd,
u8 misc_bits,
u8 flag_bits,
u16 link_widths)
static int write_vc_local_link_mode(struct hfi1_devdata *dd,
u8 misc_bits,
u8 flag_bits,
u16 link_widths)
{
u32 frame;
frame = (u32)misc_bits << MISC_CONFIG_BITS_SHIFT
| (u32)flag_bits << LOCAL_FLAG_BITS_SHIFT
| (u32)link_widths << LINK_WIDTH_SHIFT;
return load_8051_config(dd, VERIFY_CAP_LOCAL_LINK_WIDTH, GENERAL_CONFIG,
return load_8051_config(dd, VERIFY_CAP_LOCAL_LINK_MODE, GENERAL_CONFIG,
frame);
}
......@@ -9312,8 +9323,16 @@ static int set_local_link_attributes(struct hfi1_pportdata *ppd)
if (loopback == LOOPBACK_SERDES)
misc_bits |= 1 << LOOPBACK_SERDES_CONFIG_BIT_MASK_SHIFT;
ret = write_vc_local_link_width(dd, misc_bits, 0,
opa_to_vc_link_widths(
/*
* An external device configuration request is used to reset the LCB
* to retry to obtain operational lanes when the first attempt is
* unsuccesful.
*/
if (dd->dc8051_ver >= dc8051_ver(1, 25, 0))
misc_bits |= 1 << EXT_CFG_LCB_RESET_SUPPORTED_SHIFT;
ret = write_vc_local_link_mode(dd, misc_bits, 0,
opa_to_vc_link_widths(
ppd->link_width_enabled));
if (ret != HCMD_SUCCESS)
goto set_local_link_attributes_fail;
......
drivers/infiniband/hw/hfi1/chip.h
View file @ 254361c1
......@@ -196,6 +196,15 @@
#define LSTATE_ARMED 0x3
#define LSTATE_ACTIVE 0x4
/* DCC_CFG_RESET reset states */
#define LCB_RX_FPE_TX_FPE_INTO_RESET (DCC_CFG_RESET_RESET_LCB | \
DCC_CFG_RESET_RESET_TX_FPE | \
DCC_CFG_RESET_RESET_RX_FPE | \
DCC_CFG_RESET_ENABLE_CCLK_BCC)
/* 0x17 */
#define LCB_RX_FPE_TX_FPE_OUT_OF_RESET DCC_CFG_RESET_ENABLE_CCLK_BCC /* 0x10 */
/* DC8051_STS_CUR_STATE port values (physical link states) */
#define PLS_DISABLED 0x30
#define PLS_OFFLINE 0x90
......@@ -283,6 +292,7 @@
#define HREQ_SET_TX_EQ_ABS 0x04
#define HREQ_SET_TX_EQ_REL 0x05
#define HREQ_ENABLE 0x06
#define HREQ_LCB_RESET 0x07
#define HREQ_CONFIG_DONE 0xfe
#define HREQ_INTERFACE_TEST 0xff
......@@ -383,7 +393,7 @@
#define TX_SETTINGS 0x06
#define VERIFY_CAP_LOCAL_PHY 0x07
#define VERIFY_CAP_LOCAL_FABRIC 0x08
#define VERIFY_CAP_LOCAL_LINK_WIDTH 0x09
#define VERIFY_CAP_LOCAL_LINK_MODE 0x09
#define LOCAL_DEVICE_ID 0x0a
#define RESERVED_REGISTERS 0x0b
#define LOCAL_LNI_INFO 0x0c
......@@ -584,8 +594,9 @@ enum {
#define LOOPBACK_LCB 2
#define LOOPBACK_CABLE 3 /* external cable */
/* set up serdes bit in MISC_CONFIG_BITS */
/* set up bits in MISC_CONFIG_BITS */
#define LOOPBACK_SERDES_CONFIG_BIT_MASK_SHIFT 0
#define EXT_CFG_LCB_RESET_SUPPORTED_SHIFT 3
/* read and write hardware registers */
u64 read_csr(const struct hfi1_devdata *dd, u32 offset);
......
drivers/infiniband/hw/hfi1/chip_registers.h
View file @ 254361c1
......@@ -97,8 +97,11 @@
#define DCC_CFG_PORT_CONFIG_MTU_CAP_SHIFT 32
#define DCC_CFG_PORT_CONFIG_MTU_CAP_SMASK 0x700000000ull
#define DCC_CFG_RESET (DCC_CSRS + 0x000000000000)
#define DCC_CFG_RESET_RESET_LCB_SHIFT 0
#define DCC_CFG_RESET_RESET_RX_FPE_SHIFT 2
#define DCC_CFG_RESET_RESET_LCB BIT_ULL(0)
#define DCC_CFG_RESET_RESET_TX_FPE BIT_ULL(1)
#define DCC_CFG_RESET_RESET_RX_FPE BIT_ULL(2)
#define DCC_CFG_RESET_RESET_8051 BIT_ULL(3)
#define DCC_CFG_RESET_ENABLE_CCLK_BCC BIT_ULL(4)
#define DCC_CFG_SC_VL_TABLE_15_0 (DCC_CSRS + 0x000000000028)
#define DCC_CFG_SC_VL_TABLE_15_0_ENTRY0_SHIFT 0
#define DCC_CFG_SC_VL_TABLE_15_0_ENTRY10_SHIFT 40
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7