Commit 271d4c6b authored by Tony Lindgren's avatar Tony Lindgren

ARM: dts: Add support for Ethernet on some N900 macro boards

As we have support for this in board-rx51-peripherals.c, let's
add it to the .dts files too.

Note that the reset GPIO will eventually go to the driver.
For now let's just pull it down and skip any further reset
in case the bootloader has configured the MAC address so
NFSroot works.

Also note that after 3430-sdp are using proper GPMC timings
we can remove the tests for smsc,lan91c94 in gpmc.c.
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
parent a4ff93c1
......@@ -134,6 +134,14 @@ uart3_pins: pinmux_uart3_pins {
>;
};
ethernet_pins: pinmux_ethernet_pins {
pinctrl-single,pins = <
OMAP3_CORE1_IOPAD(0x20b4, PIN_INPUT_PULLDOWN | MUX_MODE4) /* gpmc_ncs3.gpio_54 */
OMAP3_CORE1_IOPAD(0x20fc, PIN_OUTPUT | MUX_MODE4) /* dss_data16.gpio_86 */
OMAP3_CORE1_IOPAD(0x219c, PIN_OUTPUT | MUX_MODE4) /* uart3_rts_sd.gpio_164 */
>;
};
i2c1_pins: pinmux_i2c1_pins {
pinctrl-single,pins = <
0x18a (PIN_INPUT | MUX_MODE0) /* i2c1_scl */
......@@ -578,6 +586,8 @@ &mmc3 {
&gpmc {
ranges = <0 0 0x04000000 0x10000000>; /* 256MB */
ranges = <0 0 0x01000000 0x01000000>, /* 16 MB for OneNAND */
<1 0 0x02000000 0x01000000>; /* 16 MB for smc91c96 */
/* gpio-irq for dma: 65 */
......@@ -646,6 +656,38 @@ partition@5 {
reg = <0x004c0000 0x0fb40000>;
};
};
ethernet@gpmc {
compatible = "smsc,lan91c94";
interrupt-parent = <&gpio2>;
interrupts = <22 IRQ_TYPE_LEVEL_HIGH>; /* gpio54 */
reg = <1 0x300 0xf>; /* 16 byte IO range at offset 0x300 */
bank-width = <2>;
pinctrl-names = "default";
pinctrl-0 = <&ethernet_pins>;
gpmc,device-width = <2>;
gpmc,sync-clk-ps = <0>;
gpmc,cs-on-ns = <0>;
gpmc,cs-rd-off-ns = <48>;
gpmc,cs-wr-off-ns = <24>;
gpmc,adv-on-ns = <0>;
gpmc,adv-rd-off-ns = <0>;
gpmc,adv-wr-off-ns = <0>;
gpmc,we-on-ns = <12>;
gpmc,we-off-ns = <18>;
gpmc,oe-on-ns = <12>;
gpmc,oe-off-ns = <48>;
gpmc,page-burst-access-ns = <0>;
gpmc,access-ns = <42>;
gpmc,rd-cycle-ns = <180>;
gpmc,wr-cycle-ns = <180>;
gpmc,bus-turnaround-ns = <0>;
gpmc,cycle2cycle-delay-ns = <0>;
gpmc,wait-monitoring-ns = <0>;
gpmc,clk-activation-ns = <0>;
gpmc,wr-access-ns = <0>;
gpmc,wr-data-mux-bus-ns = <12>;
};
};
&mcspi1 {
......
......@@ -252,6 +252,9 @@ static void __init nokia_n900_legacy_init(void)
platform_device_register(&omap3_rom_rng_device);
}
/* Only on some development boards */
gpio_request_one(164, GPIOF_OUT_INIT_LOW, "smc91x reset");
}
static void __init omap3_tao3530_legacy_init(void)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment