Commit 28c2a62b authored by Shawn Guo's avatar Shawn Guo Committed by Chris Ball

mmc: dt: bus-width can be an optional property

None of mmc drivers implements bus-width as a required device tree
property.  Instead, some drivers like atmel-mci, dw_mmc, sdhci-s3c
implement it as an optional one, and will force bus width to be 1
when the property is absent.  Let's change the common binding to
reflect what the drivers are usually doing.
Signed-off-by: default avatarShawn Guo <shawn.guo@linaro.org>
Signed-off-by: default avatarChris Ball <cjb@laptop.org>
parent af51079e
......@@ -6,9 +6,6 @@ Interpreted by the OF core:
- reg: Registers location and length.
- interrupts: Interrupts used by the MMC controller.
Required properties:
- bus-width: Number of data lines, can be <1>, <4>, or <8>
Card detection:
If no property below is supplied, host native card detect is used.
Only one of the properties in this section should be supplied:
......@@ -17,6 +14,8 @@ Only one of the properties in this section should be supplied:
- non-removable: non-removable slot (like eMMC); assume always present.
Optional properties:
- bus-width: Number of data lines, can be <1>, <4>, or <8>. The default
will be <1> if the property is absent.
- wp-gpios: Specify GPIOs for write protection, see gpio binding
- cd-inverted: when present, polarity on the cd gpio line is inverted
- wp-inverted: when present, polarity on the wp gpio line is inverted
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment