Commit 28d4d98d authored by Gabor Juhos's avatar Gabor Juhos Committed by John W. Linville

rt2x00: rt2800pci: rename rt2800pci_disable_radio function

The function contain code for SoC devices only.
Rename the function to 'rt2800soc_disable_radio'
and move it to the SoC specific section. Use
the renamed function in the SoC specific code
only and remove the 'if rt2x00_is_soc(rt2x00dev)'
condition from the function body.
Signed-off-by: default avatarGabor Juhos <juhosg@openwrt.org>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent 6716b3d8
......@@ -237,15 +237,6 @@ static int rt2800pci_enable_radio(struct rt2x00_dev *rt2x00dev)
return retval;
}
static void rt2800pci_disable_radio(struct rt2x00_dev *rt2x00dev)
{
if (rt2x00_is_soc(rt2x00dev)) {
rt2800_disable_radio(rt2x00dev);
rt2x00mmio_register_write(rt2x00dev, PWR_PIN_CFG, 0);
rt2x00mmio_register_write(rt2x00dev, TX_PIN_CFG, 0);
}
}
#ifdef CONFIG_PCI
static int rt2800pci_set_state(struct rt2x00_dev *rt2x00dev,
enum dev_state state)
......@@ -280,7 +271,6 @@ static int rt2800pci_set_device_state(struct rt2x00_dev *rt2x00dev,
* After the radio has been disabled, the device should
* be put to sleep for powersaving.
*/
rt2800pci_disable_radio(rt2x00dev);
rt2800pci_set_state(rt2x00dev, STATE_SLEEP);
break;
case STATE_RADIO_IRQ_ON:
......@@ -480,6 +470,13 @@ MODULE_DEVICE_TABLE(pci, rt2800pci_device_table);
MODULE_LICENSE("GPL");
#if defined(CONFIG_SOC_RT288X) || defined(CONFIG_SOC_RT305X)
static void rt2800soc_disable_radio(struct rt2x00_dev *rt2x00dev)
{
rt2800_disable_radio(rt2x00dev);
rt2x00mmio_register_write(rt2x00dev, PWR_PIN_CFG, 0);
rt2x00mmio_register_write(rt2x00dev, TX_PIN_CFG, 0);
}
static int rt2800soc_set_device_state(struct rt2x00_dev *rt2x00dev,
enum dev_state state)
{
......@@ -491,7 +488,7 @@ static int rt2800soc_set_device_state(struct rt2x00_dev *rt2x00dev,
break;
case STATE_RADIO_OFF:
rt2800pci_disable_radio(rt2x00dev);
rt2800soc_disable_radio(rt2x00dev);
break;
case STATE_RADIO_IRQ_ON:
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment