Commit 297357d1 authored by Florian Fainelli's avatar Florian Fainelli Committed by David S. Miller

net: systemport: Utilize bcm_sysport_set_features() during resume/open

During driver resume and open, the HW may have lost its context/state,
utilize bcm_sysport_set_features() to make sure we do restore the
correct set of features that were previously configured.
Signed-off-by: default avatarFlorian Fainelli <f.fainelli@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 10b476c5
...@@ -1972,6 +1972,11 @@ static int bcm_sysport_open(struct net_device *dev) ...@@ -1972,6 +1972,11 @@ static int bcm_sysport_open(struct net_device *dev)
else else
gib_set_pad_extension(priv); gib_set_pad_extension(priv);
/* Apply features again in case we changed them while interface was
* down
*/
bcm_sysport_set_features(dev, dev->features);
/* Set MAC address */ /* Set MAC address */
umac_set_hw_addr(priv, dev->dev_addr); umac_set_hw_addr(priv, dev->dev_addr);
...@@ -2708,7 +2713,6 @@ static int __maybe_unused bcm_sysport_resume(struct device *d) ...@@ -2708,7 +2713,6 @@ static int __maybe_unused bcm_sysport_resume(struct device *d)
struct net_device *dev = dev_get_drvdata(d); struct net_device *dev = dev_get_drvdata(d);
struct bcm_sysport_priv *priv = netdev_priv(dev); struct bcm_sysport_priv *priv = netdev_priv(dev);
unsigned int i; unsigned int i;
u32 reg;
int ret; int ret;
if (!netif_running(dev)) if (!netif_running(dev))
...@@ -2752,12 +2756,8 @@ static int __maybe_unused bcm_sysport_resume(struct device *d) ...@@ -2752,12 +2756,8 @@ static int __maybe_unused bcm_sysport_resume(struct device *d)
goto out_free_rx_ring; goto out_free_rx_ring;
} }
/* Enable rxhck */ /* Restore enabled features */
if (priv->rx_chk_en) { bcm_sysport_set_features(dev, dev->features);
reg = rxchk_readl(priv, RXCHK_CONTROL);
reg |= RXCHK_EN;
rxchk_writel(priv, reg, RXCHK_CONTROL);
}
rbuf_init(priv); rbuf_init(priv);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment