ARM: dts: stm32: move ltdc pinctrl on stm32mp157a dk1 board

The ltdc pinctrl must be in the display controller node and
not in the peripheral node (hdmi bridge).
Signed-off-by: Yannick Fertré <yannick.fertre@st.com>
Reviewed-by: Philippe Cornu <philippe.cornu@st.com>
Signed-off-by: Alexandre Torgue <alexandre.torgue@st.com>

arch/arm/boot/dts/stm32mp157a-dk1.dts

@@ -146,9 +146,6 @@ hdmi-transmitter@39 {
 		reset-gpios = <&gpioa 10 GPIO_ACTIVE_LOW>;
 		interrupts = <1 IRQ_TYPE_EDGE_FALLING>;
 		interrupt-parent = <&gpiog>;
-		pinctrl-names = "default", "sleep";
-		pinctrl-0 = <&ltdc_pins_a>;
-		pinctrl-1 = <&ltdc_pins_sleep_a>;
 		status = "okay";
 
 		ports {
@@ -356,6 +353,9 @@ &iwdg2 {
 };
 
 &ltdc {
+	pinctrl-names = "default", "sleep";
+	pinctrl-0 = <&ltdc_pins_a>;
+	pinctrl-1 = <&ltdc_pins_sleep_a>;
 	status = "okay";
 
 	port {