Blackfin: H8606/ip0x: drop redundant SPI ctl_reg settings

No need to set MSTR in .ctl_reg as the Blackfin SPI bus driver does this
already for all parts.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>

arch/blackfin/mach-bf533/boards/H8606.c

@@ -166,7 +166,6 @@ static struct bfin5xx_spi_chip spi_flash_chip_info = {
 #if defined(CONFIG_BFIN_SPI_ADC) || defined(CONFIG_BFIN_SPI_ADC_MODULE)
 /* SPI ADC chip */
 static struct bfin5xx_spi_chip spi_adc_chip_info = {
-	.ctl_reg = 0x1000,
 	.enable_dma = 1,         /* use dma transfer with this chip*/
 	.bits_per_word = 16,
 };
@@ -174,7 +173,6 @@ static struct bfin5xx_spi_chip spi_adc_chip_info = {
 
 #if defined(CONFIG_SND_BLACKFIN_AD1836) || defined(CONFIG_SND_BLACKFIN_AD1836_MODULE)
 static struct bfin5xx_spi_chip ad1836_spi_chip_info = {
-	.ctl_reg = 0x1000,
 	.enable_dma = 0,
 	.bits_per_word = 16,
 };

arch/blackfin/mach-bf533/boards/ip0x.c

@@ -107,20 +107,6 @@ static struct platform_device dm9000_device2 = {
 
 #if defined(CONFIG_MMC_SPI) || defined(CONFIG_MMC_SPI_MODULE)
 static struct bfin5xx_spi_chip mmc_spi_chip_info = {
-/*
- * CPOL (Clock Polarity)
- *  0 - Active high SCK
- *  1 - Active low SCK
- *  CPHA (Clock Phase) Selects transfer format and operation mode
- *  0 - SCLK toggles from middle of the first data bit, slave select
- *      pins controlled by hardware.
- *  1 - SCLK toggles from beginning of first data bit, slave select
- *      pins controller by user software.
- * 	.ctl_reg = 0x1c00,		 *  CPOL=1,CPHA=1,Sandisk 1G work
- * NO NO	.ctl_reg = 0x1800,		 *  CPOL=1,CPHA=0
- * NO NO	.ctl_reg = 0x1400,		 *  CPOL=0,CPHA=1
- */
-	.ctl_reg = 0x1000,		/* CPOL=0,CPHA=0,Sandisk 1G work */
 	.enable_dma = 0,		/* if 1 - block!!! */
 	.bits_per_word = 8,
 };