x86/fault: Split the OOPS code out from no_context()

Not all callers of no_context() want to run exception fixups.
Separate the OOPS code out from the fixup code in no_context().
Signed-off-by: Andy Lutomirski <luto@kernel.org>
Signed-off-by: Borislav Petkov <bp@suse.de>
Link: https://lkml.kernel.org/r/450f8d8eabafb83a5df349108c8e5ea83a2f939d.1612924255.git.luto@kernel.org

arch/x86/mm/fault.c

@@ -655,53 +655,20 @@ static void set_signal_archinfo(unsigned long address,
 }
 
 static noinline void
-no_context(struct pt_regs *regs, unsigned long error_code,
-	   unsigned long address, int signal, int si_code)
+page_fault_oops(struct pt_regs *regs, unsigned long error_code,
+		unsigned long address)
 {
-	struct task_struct *tsk = current;
 	unsigned long flags;
 	int sig;
 
 	if (user_mode(regs)) {
 		/*
-		 * This is an implicit supervisor-mode access from user
-		 * mode.  Bypass all the kernel-mode recovery code and just
-		 * OOPS.
+		 * Implicit kernel access from user mode?  Skip the stack
+		 * overflow and EFI special cases.
 		 */
 		goto oops;
 	}
 
-	/* Are we prepared to handle this kernel fault? */
-	if (fixup_exception(regs, X86_TRAP_PF, error_code, address)) {
-		/*
-		 * Any interrupt that takes a fault gets the fixup. This makes
-		 * the below recursive fault logic only apply to a faults from
-		 * task context.
-		 */
-		if (in_interrupt())
-			return;
-
-		/*
-		 * Per the above we're !in_interrupt(), aka. task context.
-		 *
-		 * In this case we need to make sure we're not recursively
-		 * faulting through the emulate_vsyscall() logic.
-		 */
-		if (current->thread.sig_on_uaccess_err && signal) {
-			sanitize_error_code(address, &error_code);
-
-			set_signal_archinfo(address, error_code);
-
-			/* XXX: hwpoison faults will set the wrong code. */
-			force_sig_fault(signal, si_code, (void __user *)address);
-		}
-
-		/*
-		 * Barring that, we can do the fixup and be happy.
-		 */
-		return;
-	}
-
 #ifdef CONFIG_VMAP_STACK
 	/*
 	 * Stack overflow?  During boot, we can fault near the initial
@@ -709,8 +676,8 @@ no_context(struct pt_regs *regs, unsigned long error_code,
 	 * that we're in vmalloc space to avoid this.
 	 */
 	if (is_vmalloc_addr((void *)address) &&
-	    (((unsigned long)tsk->stack - 1 - address < PAGE_SIZE) ||
-	     address - ((unsigned long)tsk->stack + THREAD_SIZE) < PAGE_SIZE)) {
+	    (((unsigned long)current->stack - 1 - address < PAGE_SIZE) ||
+	     address - ((unsigned long)current->stack + THREAD_SIZE) < PAGE_SIZE)) {
 		unsigned long stack = __this_cpu_ist_top_va(DF) - sizeof(void *);
 		/*
 		 * We're likely to be running with very little stack space
@@ -733,20 +700,6 @@ no_context(struct pt_regs *regs, unsigned long error_code,
 	}
 #endif
 
-	/*
-	 * 32-bit:
-	 *
-	 *   Valid to do another page fault here, because if this fault
-	 *   had been triggered by is_prefetch fixup_exception would have
-	 *   handled it.
-	 *
-	 * 64-bit:
-	 *
-	 *   Hall of shame of CPU/BIOS bugs.
-	 */
-	if (is_prefetch(regs, error_code, address))
-		return;
-
 	/*
 	 * Buggy firmware could access regions which might page fault, try to
 	 * recover from such faults.
@@ -763,7 +716,7 @@ no_context(struct pt_regs *regs, unsigned long error_code,
 
 	show_fault_oops(regs, error_code, address);
 
-	if (task_stack_end_corrupted(tsk))
+	if (task_stack_end_corrupted(current))
 		printk(KERN_EMERG "Thread overran stack, or stack corrupted\n");
 
 	sig = SIGKILL;
@@ -776,6 +729,61 @@ no_context(struct pt_regs *regs, unsigned long error_code,
 	oops_end(flags, regs, sig);
 }
 
+static noinline void
+no_context(struct pt_regs *regs, unsigned long error_code,
+	   unsigned long address, int signal, int si_code)
+{
+	if (user_mode(regs)) {
+		/*
+		 * This is an implicit supervisor-mode access from user
+		 * mode.  Bypass all the kernel-mode recovery code and just
+		 * OOPS.
+		 */
+		goto oops;
+	}
+
+	/* Are we prepared to handle this kernel fault? */
+	if (fixup_exception(regs, X86_TRAP_PF, error_code, address)) {
+		/*
+		 * Any interrupt that takes a fault gets the fixup. This makes
+		 * the below recursive fault logic only apply to a faults from
+		 * task context.
+		 */
+		if (in_interrupt())
+			return;
+
+		/*
+		 * Per the above we're !in_interrupt(), aka. task context.
+		 *
+		 * In this case we need to make sure we're not recursively
+		 * faulting through the emulate_vsyscall() logic.
+		 */
+		if (current->thread.sig_on_uaccess_err && signal) {
+			sanitize_error_code(address, &error_code);
+
+			set_signal_archinfo(address, error_code);
+
+			/* XXX: hwpoison faults will set the wrong code. */
+			force_sig_fault(signal, si_code, (void __user *)address);
+		}
+
+		/*
+		 * Barring that, we can do the fixup and be happy.
+		 */
+		return;
+	}
+
+	/*
+	 * AMD erratum #91 manifests as a spurious page fault on a PREFETCH
+	 * instruction.
+	 */
+	if (is_prefetch(regs, error_code, address))
+		return;
+
+oops:
+	page_fault_oops(regs, error_code, address);
+}
+
 /*
  * Print out info about fatal segfaults, if the show_unhandled_signals
  * sysctl is set: