s390/kdump: remove nodat stack restriction for calling nodat functions
To allow calling of DAT-off code from kernel the stack needs to be switched to nodat_stack (or other stack mapped as 1:1). Before call_nodat() macro was introduced that was necessary to provide the very same memory address for STNSM and STOSM instructions. If the kernel would stay on a random stack (e.g. a virtually mapped one) then a virtual address provided for STNSM instruction could differ from the physical address needed for the corresponding STOSM instruction. After call_nodat() macro is introduced the kernel stack does not need to be mapped 1:1 anymore, since the macro stores the physical memory address of return PSW in a register before entering DAT-off mode. This way the return LPSWE instruction is able to pick the correct memory location and restore the DAT-on mode. That however might fail in case the 16-byte return PSW happened to cross page boundary: PSW mask and PSW address could end up in two separate non-contiguous physical pages. Align the return PSW on 16-byte boundary so it always fits into a single physical page. As result any stack (including the virtually mapped one) could be used for calling DAT-off code and prior switching to nodat_stack becomes unnecessary. Signed-off-by: Alexander Gordeev <agordeev@linux.ibm.com> Reviewed-by: Heiko Carstens <hca@linux.ibm.com> Signed-off-by: Heiko Carstens <hca@linux.ibm.com> Signed-off-by: Vasily Gorbik <gor@linux.ibm.com>
Showing
Please register or sign in to comment