Commit 2f2cc27f authored by Ying-Chun Liu (PaulLiu)'s avatar Ying-Chun Liu (PaulLiu) Committed by Mark Brown

regulator: anatop: patching to device-tree property "reg".

Change "reg" to "anatop-reg-offset" due to there is a warning of handling no
size field in reg.

This patch also adds the missing device-tree binding documentation.
Signed-off-by: default avatarYing-Chun Liu (PaulLiu) <paul.liu@linaro.org>
Acked-by: default avatarShawn Guo <shawn.guo@linaro.org>
Signed-off-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
parent 93009286
Anatop Voltage regulators
Required properties:
- compatible: Must be "fsl,anatop-regulator"
- anatop-reg-offset: Anatop MFD register offset
- anatop-vol-bit-shift: Bit shift for the register
- anatop-vol-bit-width: Number of bits used in the register
- anatop-min-bit-val: Minimum value of this register
- anatop-min-voltage: Minimum voltage of this regulator
- anatop-max-voltage: Maximum voltage of this regulator
Any property defined as part of the core regulator
binding, defined in regulator.txt, can also be used.
Example:
regulator-vddpu {
compatible = "fsl,anatop-regulator";
regulator-name = "vddpu";
regulator-min-microvolt = <725000>;
regulator-max-microvolt = <1300000>;
regulator-always-on;
anatop-reg-offset = <0x140>;
anatop-vol-bit-shift = <9>;
anatop-vol-bit-width = <5>;
anatop-min-bit-val = <1>;
anatop-min-voltage = <725000>;
anatop-max-voltage = <1300000>;
};
......@@ -138,9 +138,10 @@ static int __devinit anatop_regulator_probe(struct platform_device *pdev)
rdesc->type = REGULATOR_VOLTAGE;
rdesc->owner = THIS_MODULE;
sreg->mfd = anatopmfd;
ret = of_property_read_u32(np, "reg", &sreg->control_reg);
ret = of_property_read_u32(np, "anatop-reg-offset",
&sreg->control_reg);
if (ret) {
dev_err(dev, "no reg property set\n");
dev_err(dev, "no anatop-reg-offset property set\n");
goto anatop_probe_end;
}
ret = of_property_read_u32(np, "anatop-vol-bit-width",
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment