Commit 2fb04fdf authored by Russell King's avatar Russell King Committed by David S. Miller

net: smc91x: fix SMC accesses

Commit b70661c7 ("net: smc91x: use run-time configuration on all ARM
machines") broke some ARM platforms through several mistakes.  Firstly,
the access size must correspond to the following rule:

(a) at least one of 16-bit or 8-bit access size must be supported
(b) 32-bit accesses are optional, and may be enabled in addition to
    the above.

Secondly, it provides no emulation of 16-bit accesses, instead blindly
making 16-bit accesses even when the platform specifies that only 8-bit
is supported.

Reorganise smc91x.h so we can make use of the existing 16-bit access
emulation already provided - if 16-bit accesses are supported, use
16-bit accesses directly, otherwise if 8-bit accesses are supported,
use the provided 16-bit access emulation.  If neither, BUG().  This
exactly reflects the driver behaviour prior to the commit being fixed.

Since the conversion incorrectly cut down the available access sizes on
several platforms, we also need to go through every platform and fix up
the overly-restrictive access size: Arnd assumed that if a platform can
perform 32-bit, 16-bit and 8-bit accesses, then only a 32-bit access
size needed to be specified - not so, all available access sizes must
be specified.

This likely fixes some performance regressions in doing this: if a
platform does not support 8-bit accesses, 8-bit accesses have been
emulated by performing a 16-bit read-modify-write access.

Tested on the Intel Assabet/Neponset platform, which supports only 8-bit
accesses, which was broken by the original commit.

Fixes: b70661c7 ("net: smc91x: use run-time configuration on all ARM machines")
Signed-off-by: default avatarRussell King <rmk+kernel@armlinux.org.uk>
Tested-by: default avatarRobert Jarzmik <robert.jarzmik@free.fr>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 7d13eca0
......@@ -83,7 +83,8 @@ static struct resource smc91x_resources[] = {
};
static struct smc91x_platdata smc91x_platdata = {
.flags = SMC91X_USE_32BIT | SMC91X_USE_DMA | SMC91X_NOWAIT,
.flags = SMC91X_USE_8BIT | SMC91X_USE_16BIT | SMC91X_USE_32BIT |
SMC91X_USE_DMA | SMC91X_NOWAIT,
};
static struct platform_device smc91x_device = {
......
......@@ -120,7 +120,8 @@ static struct resource smc91x_resources[] = {
};
static struct smc91x_platdata xcep_smc91x_info = {
.flags = SMC91X_USE_32BIT | SMC91X_NOWAIT | SMC91X_USE_DMA,
.flags = SMC91X_USE_8BIT | SMC91X_USE_16BIT | SMC91X_USE_32BIT |
SMC91X_NOWAIT | SMC91X_USE_DMA,
};
static struct platform_device smc91x_device = {
......
......@@ -93,7 +93,8 @@ static struct smsc911x_platform_config smsc911x_config = {
};
static struct smc91x_platdata smc91x_platdata = {
.flags = SMC91X_USE_32BIT | SMC91X_NOWAIT,
.flags = SMC91X_USE_8BIT | SMC91X_USE_16BIT | SMC91X_USE_32BIT |
SMC91X_NOWAIT,
};
static struct platform_device realview_eth_device = {
......
......@@ -45,7 +45,7 @@ static struct resource smc91x_resources[] = {
};
static struct smc91x_platdata smc91x_platdata = {
.flags = SMC91X_USE_16BIT | SMC91X_NOWAIT,
.flags = SMC91X_USE_16BIT | SMC91X_USE_8BIT | SMC91X_NOWAIT,
};
static struct platform_device smc91x_device = {
......
......@@ -146,7 +146,8 @@ static struct platform_device hitachi_fb_device = {
#include <linux/smc91x.h>
static struct smc91x_platdata smc91x_info = {
.flags = SMC91X_USE_32BIT | SMC91X_NOWAIT,
.flags = SMC91X_USE_8BIT | SMC91X_USE_16BIT | SMC91X_USE_32BIT |
SMC91X_NOWAIT,
.leda = RPC_LED_100_10,
.ledb = RPC_LED_TX_RX,
};
......
......@@ -134,7 +134,8 @@ static struct platform_device net2272_bfin_device = {
#include <linux/smc91x.h>
static struct smc91x_platdata smc91x_info = {
.flags = SMC91X_USE_32BIT | SMC91X_NOWAIT,
.flags = SMC91X_USE_8BIT | SMC91X_USE_16BIT | SMC91X_USE_32BIT |
SMC91X_NOWAIT,
.leda = RPC_LED_100_10,
.ledb = RPC_LED_TX_RX,
};
......
......@@ -2275,6 +2275,13 @@ static int smc_drv_probe(struct platform_device *pdev)
if (pd) {
memcpy(&lp->cfg, pd, sizeof(lp->cfg));
lp->io_shift = SMC91X_IO_SHIFT(lp->cfg.flags);
if (!SMC_8BIT(lp) && !SMC_16BIT(lp)) {
dev_err(&pdev->dev,
"at least one of 8-bit or 16-bit access support is required.\n");
ret = -ENXIO;
goto out_free_netdev;
}
}
#if IS_BUILTIN(CONFIG_OF)
......
......@@ -36,6 +36,27 @@
#include <linux/dmaengine.h>
#include <linux/smc91x.h>
/*
* Any 16-bit access is performed with two 8-bit accesses if the hardware
* can't do it directly. Most registers are 16-bit so those are mandatory.
*/
#define SMC_outw_b(x, a, r) \
do { \
unsigned int __val16 = (x); \
unsigned int __reg = (r); \
SMC_outb(__val16, a, __reg); \
SMC_outb(__val16 >> 8, a, __reg + (1 << SMC_IO_SHIFT)); \
} while (0)
#define SMC_inw_b(a, r) \
({ \
unsigned int __val16; \
unsigned int __reg = r; \
__val16 = SMC_inb(a, __reg); \
__val16 |= SMC_inb(a, __reg + (1 << SMC_IO_SHIFT)) << 8; \
__val16; \
})
/*
* Define your architecture specific bus configuration parameters here.
*/
......@@ -55,10 +76,30 @@
#define SMC_IO_SHIFT (lp->io_shift)
#define SMC_inb(a, r) readb((a) + (r))
#define SMC_inw(a, r) readw((a) + (r))
#define SMC_inw(a, r) \
({ \
unsigned int __smc_r = r; \
SMC_16BIT(lp) ? readw((a) + __smc_r) : \
SMC_8BIT(lp) ? SMC_inw_b(a, __smc_r) : \
({ BUG(); 0; }); \
})
#define SMC_inl(a, r) readl((a) + (r))
#define SMC_outb(v, a, r) writeb(v, (a) + (r))
#define SMC_outw(v, a, r) \
do { \
unsigned int __v = v, __smc_r = r; \
if (SMC_16BIT(lp)) \
__SMC_outw(__v, a, __smc_r); \
else if (SMC_8BIT(lp)) \
SMC_outw_b(__v, a, __smc_r); \
else \
BUG(); \
} while (0)
#define SMC_outl(v, a, r) writel(v, (a) + (r))
#define SMC_insb(a, r, p, l) readsb((a) + (r), p, l)
#define SMC_outsb(a, r, p, l) writesb((a) + (r), p, l)
#define SMC_insw(a, r, p, l) readsw((a) + (r), p, l)
#define SMC_outsw(a, r, p, l) writesw((a) + (r), p, l)
#define SMC_insl(a, r, p, l) readsl((a) + (r), p, l)
......@@ -66,7 +107,7 @@
#define SMC_IRQ_FLAGS (-1) /* from resource */
/* We actually can't write halfwords properly if not word aligned */
static inline void SMC_outw(u16 val, void __iomem *ioaddr, int reg)
static inline void __SMC_outw(u16 val, void __iomem *ioaddr, int reg)
{
if ((machine_is_mainstone() || machine_is_stargate2() ||
machine_is_pxa_idp()) && reg & 2) {
......@@ -416,24 +457,8 @@ smc_pxa_dma_insw(void __iomem *ioaddr, struct smc_local *lp, int reg, int dma,
#if ! SMC_CAN_USE_16BIT
/*
* Any 16-bit access is performed with two 8-bit accesses if the hardware
* can't do it directly. Most registers are 16-bit so those are mandatory.
*/
#define SMC_outw(x, ioaddr, reg) \
do { \
unsigned int __val16 = (x); \
SMC_outb( __val16, ioaddr, reg ); \
SMC_outb( __val16 >> 8, ioaddr, reg + (1 << SMC_IO_SHIFT));\
} while (0)
#define SMC_inw(ioaddr, reg) \
({ \
unsigned int __val16; \
__val16 = SMC_inb( ioaddr, reg ); \
__val16 |= SMC_inb( ioaddr, reg + (1 << SMC_IO_SHIFT)) << 8; \
__val16; \
})
#define SMC_outw(x, ioaddr, reg) SMC_outw_b(x, ioaddr, reg)
#define SMC_inw(ioaddr, reg) SMC_inw_b(ioaddr, reg)
#define SMC_insw(a, r, p, l) BUG()
#define SMC_outsw(a, r, p, l) BUG()
......
#ifndef __SMC91X_H__
#define __SMC91X_H__
/*
* These bits define which access sizes a platform can support, rather
* than the maximal access size. So, if your platform can do 16-bit
* and 32-bit accesses to the SMC91x device, but not 8-bit, set both
* SMC91X_USE_16BIT and SMC91X_USE_32BIT.
*
* The SMC91x driver requires at least one of SMC91X_USE_8BIT or
* SMC91X_USE_16BIT to be supported - just setting SMC91X_USE_32BIT is
* an invalid configuration.
*/
#define SMC91X_USE_8BIT (1 << 0)
#define SMC91X_USE_16BIT (1 << 1)
#define SMC91X_USE_32BIT (1 << 2)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment