extcon: intel-cht-wc: Make charger detection co-existed with OTG host mode

Whiskey Cove Cherry Trail PMIC requires disabling OTG host mode before
of charger detection procedure. Do this by manipulationg of CHGRCTRL1
register.

Source: APCI DSDT code of Lenovo Yoga Book YB1-X91L and open-sourced
Intel's drivers.
Signed-off-by: Yauhen Kharuzhy <jekhor@gmail.com>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Reviewed-by: Hans de Goede <hdegoede@redhat.com>
Tested-by: Hans de Goede <hdegoede@redhat.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>

drivers/extcon/extcon-intel-cht-wc.c

@@ -29,7 +29,15 @@
 #define CHT_WC_CHGRCTRL0_DBPOFF		BIT(6)
 #define CHT_WC_CHGRCTRL0_CHR_WDT_NOKICK	BIT(7)
 
-#define CHT_WC_CHGRCTRL1		0x5e17
+#define CHT_WC_CHGRCTRL1			0x5e17
+#define CHT_WC_CHGRCTRL1_FUSB_INLMT_100		BIT(0)
+#define CHT_WC_CHGRCTRL1_FUSB_INLMT_150		BIT(1)
+#define CHT_WC_CHGRCTRL1_FUSB_INLMT_500		BIT(2)
+#define CHT_WC_CHGRCTRL1_FUSB_INLMT_900		BIT(3)
+#define CHT_WC_CHGRCTRL1_FUSB_INLMT_1500	BIT(4)
+#define CHT_WC_CHGRCTRL1_FTEMP_EVENT		BIT(5)
+#define CHT_WC_CHGRCTRL1_OTGMODE		BIT(6)
+#define CHT_WC_CHGRCTRL1_DBPEN			BIT(7)
 
 #define CHT_WC_USBSRC			0x5e29
 #define CHT_WC_USBSRC_STS_MASK		GENMASK(1, 0)
@@ -198,6 +206,18 @@ static void cht_wc_extcon_set_5v_boost(struct cht_wc_extcon_data *ext,
 		dev_err(ext->dev, "Error writing Vbus GPIO CTLO: %d\n", ret);
 }
 
+static void cht_wc_extcon_set_otgmode(struct cht_wc_extcon_data *ext,
+				      bool enable)
+{
+	unsigned int val = enable ? CHT_WC_CHGRCTRL1_OTGMODE : 0;
+	int ret;
+
+	ret = regmap_update_bits(ext->regmap, CHT_WC_CHGRCTRL1,
+				 CHT_WC_CHGRCTRL1_OTGMODE, val);
+	if (ret)
+		dev_err(ext->dev, "Error updating CHGRCTRL1 reg: %d\n", ret);
+}
+
 /* Small helper to sync EXTCON_CHG_USB_SDP and EXTCON_USB state */
 static void cht_wc_extcon_set_state(struct cht_wc_extcon_data *ext,
 				    unsigned int cable, bool state)
@@ -222,10 +242,14 @@ static void cht_wc_extcon_pwrsrc_event(struct cht_wc_extcon_data *ext)
 
 	id = cht_wc_extcon_get_id(ext, pwrsrc_sts);
 	if (id == USB_ID_GND) {
+		cht_wc_extcon_set_otgmode(ext, true);
+
 		/* The 5v boost causes a false VBUS / SDP detect, skip */
 		goto charger_det_done;
 	}
 
+	cht_wc_extcon_set_otgmode(ext, false);
+
 	/* Plugged into a host/charger or not connected? */
 	if (!(pwrsrc_sts & CHT_WC_PWRSRC_VBUS)) {
 		/* Route D+ and D- to PMIC for future charger detection */