Commit 314bd842 authored by Amit Cohen's avatar Amit Cohen Committed by David S. Miller

mlxsw: spectrum_router: Skip loopback RIFs during MAC validation

When a router interface (RIF) is created the MAC address of the backing
netdev is verified to have the same MSBs as existing RIFs. This is
required in order to avoid changing existing RIF MAC addresses that all
share the same MSBs.

Loopback RIFs are special in this regard as they do not have a MAC
address, given they are only used to loop packets from the overlay to
the underlay.

Without this change, an error is returned when trying to create a RIF
after the creation of a GRE tunnel that is represented by a loopback
RIF. 'rif->dev->dev_addr' points to the GRE device's local IP, which
does not share the same MSBs as physical interfaces. Adding an IP
address to any physical interface results in:

Error: mlxsw_spectrum: All router interface MAC addresses must have the
same prefix.

Fix this by skipping loopback RIFs during MAC validation.

Fixes: 74bc9939 ("mlxsw: spectrum_router: Veto unsupported RIF MAC addresses")
Signed-off-by: default avatarAmit Cohen <amitc@mellanox.com>
Signed-off-by: default avatarIdo Schimmel <idosch@mellanox.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent bd6f4854
...@@ -7079,6 +7079,9 @@ static int mlxsw_sp_router_port_check_rif_addr(struct mlxsw_sp *mlxsw_sp, ...@@ -7079,6 +7079,9 @@ static int mlxsw_sp_router_port_check_rif_addr(struct mlxsw_sp *mlxsw_sp,
for (i = 0; i < MLXSW_CORE_RES_GET(mlxsw_sp->core, MAX_RIFS); i++) { for (i = 0; i < MLXSW_CORE_RES_GET(mlxsw_sp->core, MAX_RIFS); i++) {
rif = mlxsw_sp->router->rifs[i]; rif = mlxsw_sp->router->rifs[i];
if (rif && rif->ops &&
rif->ops->type == MLXSW_SP_RIF_TYPE_IPIP_LB)
continue;
if (rif && rif->dev && rif->dev != dev && if (rif && rif->dev && rif->dev != dev &&
!ether_addr_equal_masked(rif->dev->dev_addr, dev_addr, !ether_addr_equal_masked(rif->dev->dev_addr, dev_addr,
mlxsw_sp->mac_mask)) { mlxsw_sp->mac_mask)) {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment