scsi: megaraid_sas: reduce module load time

megaraid_sas takes 1+ seconds to load while waiting for firmware:

[2.822603] megaraid_sas 0000:03:00.0: Waiting for FW to come to ready state
[3.871003] megaraid_sas 0000:03:00.0: FW now in Ready state

This is due to the following loop in megasas_transition_to_ready(), which
waits a minimum of 1 second, even though the FW becomes ready in tens of
millisecs:

        /*
         * The cur_state should not last for more than max_wait secs
         */
        for (i = 0; i < max_wait; i++) {
                ...
                msleep(1000);
        ...
        dev_info(&instance->pdev->dev, "FW now in Ready state\n");

This is a regression, caused by a change of the msleep granularity from 1
to 1000 due to concern about waiting too long on systems with coarse
jiffies.

To fix, increase iterations and use msleep(20), which results in:

[2.670627] megaraid_sas 0000:03:00.0: Waiting for FW to come to ready state
[2.739386] megaraid_sas 0000:03:00.0: FW now in Ready state

Fixes: fb2f3e96d80f ("scsi: megaraid_sas: Fix msleep granularity")
Signed-off-by: Steve Sistare <steven.sistare@oracle.com>
Acked-by: Sumit Saxena <sumit.saxena@broadcom.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

drivers/scsi/megaraid/megaraid_sas_base.c

@@ -3924,12 +3924,12 @@ megasas_transition_to_ready(struct megasas_instance *instance, int ocr)
 		/*
 		 * The cur_state should not last for more than max_wait secs
 		 */
-		for (i = 0; i < max_wait; i++) {
+		for (i = 0; i < max_wait * 50; i++) {
 			curr_abs_state = instance->instancet->
 				read_fw_status_reg(instance);
 
 			if (abs_state == curr_abs_state) {
-				msleep(1000);
+				msleep(20);
 			} else
 				break;
 		}