staging: comedi: Align the * on block comments

Block comments should align the * on each line as reported by checkpatch
Signed-off-by: Jakub Jedelsky <jakub.jedelsky@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/staging/comedi/drivers/cb_pcidda.c

@@ -248,8 +248,8 @@ static void cb_pcidda_write_caldac(struct comedi_device *dev,
 	cb_pcidda_serial_out(dev, value, num_caldac_bits);
 
 /*
-* latch stream into appropriate caldac deselect reference dac
-*/
+ * latch stream into appropriate caldac deselect reference dac
+ */
 	cal2_bits = DESELECT_REF_DAC_BIT | DUMMY_BIT;
 	/*  deactivate caldacs (one caldac for every two channels) */
 	for (i = 0; i < max_num_caldacs; i++)

drivers/staging/comedi/drivers/mite.c

@@ -837,7 +837,7 @@ static int mite_setup(struct comedi_device *dev, struct mite *mite,
 	 * of 0x61f and bursts worked. 6281 powered up with register value of
 	 * 0x1f and bursts didn't work. The NI windows driver reads the
 	 * register, then does a bitwise-or of 0x600 with it and writes it back.
-	*
+	 *
 	 * The bits 0x90180700 in MITE_UNKNOWN_DMA_BURST_REG can be
 	 * written and read back.  The bits 0x1f always read as 1.
 	 * The rest always read as zero.

drivers/staging/comedi/drivers/pcl818.c

@@ -771,9 +771,9 @@ static int pcl818_ai_cancel(struct comedi_device *dev,
 		     s->async->scans_done < cmd->stop_arg)) {
 			if (!devpriv->ai_cmd_canceled) {
 				/*
-				* Wait for running dma transfer to end,
-				* do cleanup in interrupt.
-				*/
+				 * Wait for running dma transfer to end,
+				 * do cleanup in interrupt.
+				 */
 				devpriv->ai_cmd_canceled = 1;
 				return 0;
 			}