Merge branch 'for-usb' of...

Merge branch 'for-usb' of git://git.kernel.org/pub/scm/linux/kernel/git/geoff/ps3-linux into usb-next

* 'for-usb' of git://git.kernel.org/pub/scm/linux/kernel/git/geoff/ps3-linux:
  usb: PS3 EHCI QH read work-around
  usb: Fix PS3 EHCI suspend
  usb: PS3 EHCI HC reset work-around
  usb: Remove ehci_reset call from ehci_run

drivers/usb/host/ehci-au1xxx.c

@@ -23,6 +23,7 @@ static int au1xxx_ehci_setup(struct usb_hcd *hcd)
 	int ret = ehci_init(hcd);
 
 	ehci->need_io_watchdog = 0;
+	ehci_reset(ehci);
 	return ret;
 }
 

drivers/usb/host/ehci-hcd.c

@@ -48,6 +48,10 @@
 #include <asm/system.h>
 #include <asm/unaligned.h>
 
+#if defined(CONFIG_PPC_PS3)
+#include <asm/firmware.h>
+#endif
+
 /*-------------------------------------------------------------------------*/
 
 /*
@@ -230,12 +234,58 @@ static int ehci_halt (struct ehci_hcd *ehci)
 			  STS_HALT, STS_HALT, 16 * 125);
 }
 
+#if defined(CONFIG_USB_SUSPEND) && defined(CONFIG_PPC_PS3)
+
+/*
+ * The EHCI controller of the Cell Super Companion Chip used in the
+ * PS3 will stop the root hub after all root hub ports are suspended.
+ * When in this condition handshake will return -ETIMEDOUT.  The
+ * STS_HLT bit will not be set, so inspection of the frame index is
+ * used here to test for the condition.  If the condition is found
+ * return success to allow the USB suspend to complete.
+ */
+
+static int handshake_for_broken_root_hub(struct ehci_hcd *ehci,
+					 void __iomem *ptr, u32 mask, u32 done,
+					 int usec)
+{
+	unsigned int old_index;
+	int error;
+
+	if (!firmware_has_feature(FW_FEATURE_PS3_LV1))
+		return -ETIMEDOUT;
+
+	old_index = ehci_read_frame_index(ehci);
+
+	error = handshake(ehci, ptr, mask, done, usec);
+
+	if (error == -ETIMEDOUT && ehci_read_frame_index(ehci) == old_index)
+		return 0;
+
+	return error;
+}
+
+#else
+
+static int handshake_for_broken_root_hub(struct ehci_hcd *ehci,
+					 void __iomem *ptr, u32 mask, u32 done,
+					 int usec)
+{
+	return -ETIMEDOUT;
+}
+
+#endif
+
 static int handshake_on_error_set_halt(struct ehci_hcd *ehci, void __iomem *ptr,
 				       u32 mask, u32 done, int usec)
 {
 	int error;
 
 	error = handshake(ehci, ptr, mask, done, usec);
+	if (error == -ETIMEDOUT)
+		error = handshake_for_broken_root_hub(ehci, ptr, mask, done,
+						      usec);
+
 	if (error) {
 		ehci_halt(ehci);
 		ehci->rh_state = EHCI_RH_HALTED;
@@ -620,6 +670,7 @@ static int ehci_init(struct usb_hcd *hcd)
 	hw = ehci->async->hw;
 	hw->hw_next = QH_NEXT(ehci, ehci->async->qh_dma);
 	hw->hw_info1 = cpu_to_hc32(ehci, QH_HEAD);
+	hw->hw_info1 |= cpu_to_hc32(ehci, (1 << 7));	/* I = 1 */
 	hw->hw_token = cpu_to_hc32(ehci, QTD_STS_HALT);
 	hw->hw_qtd_next = EHCI_LIST_END(ehci);
 	ehci->async->qh_state = QH_STATE_LINKED;
@@ -677,22 +728,13 @@ static int ehci_init(struct usb_hcd *hcd)
 static int ehci_run (struct usb_hcd *hcd)
 {
 	struct ehci_hcd		*ehci = hcd_to_ehci (hcd);
-	int			retval;
 	u32			temp;
 	u32			hcc_params;
 
 	hcd->uses_new_polling = 1;
 
 	/* EHCI spec section 4.1 */
-	/*
-	 * TDI driver does the ehci_reset in their reset callback.
-	 * Don't reset here, because configuration settings will
-	 * vanish.
-	 */
-	if (!ehci_is_TDI(ehci) && (retval = ehci_reset(ehci)) != 0) {
-		ehci_mem_cleanup(ehci);
-		return retval;
-	}
+
 	ehci_writel(ehci, ehci->periodic_dma, &ehci->regs->frame_list);
 	ehci_writel(ehci, (u32)ehci->async->qh_dma, &ehci->regs->async_next);
 

drivers/usb/host/ehci-octeon.c

@@ -155,6 +155,8 @@ static int ehci_octeon_drv_probe(struct platform_device *pdev)
 	/* cache this readonly data; minimize chip reads */
 	ehci->hcs_params = ehci_readl(ehci, &ehci->caps->hcs_params);
 
+	ehci_reset(ehci);
+
 	ret = usb_add_hcd(hcd, irq, IRQF_SHARED);
 	if (ret) {
 		dev_dbg(&pdev->dev, "failed to add hcd with err %d\n", ret);

drivers/usb/host/ehci-omap.c

@@ -228,6 +228,8 @@ static int ehci_hcd_omap_probe(struct platform_device *pdev)
 	/* cache this readonly data; minimize chip reads */
 	omap_ehci->hcs_params = readl(&omap_ehci->caps->hcs_params);
 
+	ehci_reset(omap_ehci);
+
 	ret = usb_add_hcd(hcd, irq, IRQF_SHARED);
 	if (ret) {
 		dev_err(dev, "failed to add hcd with err %d\n", ret);

drivers/usb/host/ehci-ps3.c

@@ -21,6 +21,34 @@
 #include <asm/firmware.h>
 #include <asm/ps3.h>
 
+static void ps3_ehci_setup_insnreg(struct ehci_hcd *ehci)
+{
+	/* PS3 HC internal setup register offsets. */
+
+	enum ps3_ehci_hc_insnreg {
+		ps3_ehci_hc_insnreg01 = 0x084,
+		ps3_ehci_hc_insnreg02 = 0x088,
+		ps3_ehci_hc_insnreg03 = 0x08c,
+	};
+
+	/* PS3 EHCI HC errata fix 316 - The PS3 EHCI HC will reset its
+	 * internal INSNREGXX setup regs back to the chip default values
+	 * on Host Controller Reset (CMD_RESET) or Light Host Controller
+	 * Reset (CMD_LRESET).  The work-around for this is for the HC
+	 * driver to re-initialise these regs when ever the HC is reset.
+	 */
+
+	/* Set burst transfer counts to 256 out, 32 in. */
+
+	writel_be(0x01000020, (void __iomem *)ehci->regs +
+		ps3_ehci_hc_insnreg01);
+
+	/* Enable burst transfer counts. */
+
+	writel_be(0x00000001, (void __iomem *)ehci->regs +
+		ps3_ehci_hc_insnreg03);
+}
+
 static int ps3_ehci_hc_reset(struct usb_hcd *hcd)
 {
 	int result;
@@ -49,6 +77,8 @@ static int ps3_ehci_hc_reset(struct usb_hcd *hcd)
 
 	ehci_reset(ehci);
 
+	ps3_ehci_setup_insnreg(ehci);
+
 	return result;
 }
 

drivers/usb/host/ehci-s5p.c

@@ -134,6 +134,8 @@ static int __devinit s5p_ehci_probe(struct platform_device *pdev)
 	/* cache this readonly data; minimize chip reads */
 	ehci->hcs_params = readl(&ehci->caps->hcs_params);
 
+	ehci_reset(ehci);
+
 	err = usb_add_hcd(hcd, irq, IRQF_SHARED);
 	if (err) {
 		dev_err(&pdev->dev, "Failed to add USB HCD\n");

drivers/usb/host/ehci-vt8500.c

@@ -132,6 +132,8 @@ static int vt8500_ehci_drv_probe(struct platform_device *pdev)
 
 	ehci_port_power(ehci, 1);
 
+	ehci_reset(ehci);
+
 	ret = usb_add_hcd(hcd, pdev->resource[1].start,
 			  IRQF_SHARED);
 	if (ret == 0) {

drivers/usb/host/ehci-w90x900.c

@@ -78,6 +78,8 @@ static int __devinit usb_w90x900_probe(const struct hc_driver *driver,
 	if (irq < 0)
 		goto err4;
 
+	ehci_reset(ehci);
+
 	retval = usb_add_hcd(hcd, irq, IRQF_SHARED);
 	if (retval != 0)
 		goto err4;