Commit 337cce7e authored by Chen-Yu Tsai's avatar Chen-Yu Tsai Committed by Maxime Ripard

ARM: dts: sun8i: a83t: bananapi-m3: Enable AP6212 WiFi on mmc1

The WiFi side of the AP6212 WiFi/BT combo module is connected to
mmc1. There are also GPIOs for enable and interrupts. An external
clock from the AC100 RTC is also used.

Enable WiFi on this board by enabling mmc1 and adding the power
sequencing clocks and GPIO, as well as the chip's interrupt line.
Signed-off-by: default avatarChen-Yu Tsai <wens@csie.org>
Signed-off-by: default avatarMaxime Ripard <maxime.ripard@free-electrons.com>
parent f346019b
...@@ -68,6 +68,17 @@ reg_usb1_vbus: reg-usb1-vbus { ...@@ -68,6 +68,17 @@ reg_usb1_vbus: reg-usb1-vbus {
enable-active-high; enable-active-high;
gpio = <&pio 3 24 GPIO_ACTIVE_HIGH>; /* PD24 */ gpio = <&pio 3 24 GPIO_ACTIVE_HIGH>; /* PD24 */
}; };
wifi_pwrseq: wifi_pwrseq {
compatible = "mmc-pwrseq-simple";
clocks = <&ac100_rtc 1>;
clock-names = "ext_clock";
/* The WiFi low power clock must be 32768 Hz */
assigned-clocks = <&ac100_rtc 1>;
assigned-clock-rates = <32768>;
/* enables internal regulator and de-asserts reset */
reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* PL2 WL-PMU-EN */
};
}; };
&ehci0 { &ehci0 {
...@@ -87,6 +98,23 @@ &mmc0 { ...@@ -87,6 +98,23 @@ &mmc0 {
status = "okay"; status = "okay";
}; };
&mmc1 {
vmmc-supply = <&reg_dldo1>;
vqmmc-supply = <&reg_dldo1>;
mmc-pwrseq = <&wifi_pwrseq>;
bus-width = <4>;
non-removable;
status = "okay";
brcmf: wifi@1 {
reg = <1>;
compatible = "brcm,bcm4329-fmac";
interrupt-parent = <&r_pio>;
interrupts = <0 3 IRQ_TYPE_LEVEL_LOW>;
interrupt-names = "host-wake";
};
};
&mmc2 { &mmc2 {
pinctrl-names = "default"; pinctrl-names = "default";
pinctrl-0 = <&mmc2_8bit_emmc_pins>; pinctrl-0 = <&mmc2_8bit_emmc_pins>;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment