Commit 34f26536 authored by Suman Anna's avatar Suman Anna Committed by Bjorn Andersson

remoteproc: k3-r5: Initialize TCM memories for ECC

The R5F processors on K3 SoCs all have two TCMs (ATCM and BTCM) that
support 32-bit ECC. The TCMs are typically loaded with some boot-up
code to initialize the R5 MPUs to further execute code out of DDR.
The ECC for the TCMs is enabled by default on K3 SoCs due to internal
default tie-off values, but the TCM memories are not initialized on
device power up. Any read access without the corresponding TCM memory
location initialized will generate an ECC error, and any such access
from a A72 or A53 core will trigger a SError.

So, zero initialize both the TCM memories before loading any firmware
onto a R5F in remoteproc mode. Any R5F booted from U-Boot/SPL would
require a similar initialization in the bootloader. Note that both
the TCMs are initialized unconditionally as the TCM enable config bits
only manage the access and visibility from R5.
Signed-off-by: default avatarSuman Anna <s-anna@ti.com>
Reviewed-by: default avatarMathieu Poirier <mathieu.poirier@linaro.org>
Link: https://lore.kernel.org/r/20201002234234.20704-4-s-anna@ti.comSigned-off-by: default avatarBjorn Andersson <bjorn.andersson@linaro.org>
parent 6dedbd1d
...@@ -362,11 +362,24 @@ static int k3_r5_rproc_prepare(struct rproc *rproc) ...@@ -362,11 +362,24 @@ static int k3_r5_rproc_prepare(struct rproc *rproc)
ret = (cluster->mode == CLUSTER_MODE_LOCKSTEP) ? ret = (cluster->mode == CLUSTER_MODE_LOCKSTEP) ?
k3_r5_lockstep_release(cluster) : k3_r5_split_release(core); k3_r5_lockstep_release(cluster) : k3_r5_split_release(core);
if (ret) if (ret) {
dev_err(dev, "unable to enable cores for TCM loading, ret = %d\n", dev_err(dev, "unable to enable cores for TCM loading, ret = %d\n",
ret); ret);
return ret;
}
return ret; /*
* Zero out both TCMs unconditionally (access from v8 Arm core is not
* affected by ATCM & BTCM enable configuration values) so that ECC
* can be effective on all TCM addresses.
*/
dev_dbg(dev, "zeroing out ATCM memory\n");
memset(core->mem[0].cpu_addr, 0x00, core->mem[0].size);
dev_dbg(dev, "zeroing out BTCM memory\n");
memset(core->mem[1].cpu_addr, 0x00, core->mem[1].size);
return 0;
} }
/* /*
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment