spi: Add SPI master driver for DaVinci/DA8xx

This patch adds support for a SPI master driver for the
DaVinci series of SOCs
Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>
Signed-off-by: Mark A. Greer <mgreer@mvista.com>
Signed-off-by: Philby John <pjohn@in.mvista.com>
Signed-off-by: Sudhakar Rajashekhara <sudhakar.raj@ti.com>
Signed-off-by: Kevin Hilman <khilman@deeprootsystems.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

drivers/spi/Kconfig

@@ -100,6 +100,13 @@ config SPI_BUTTERFLY
 	  inexpensive battery powered microcontroller evaluation board.
 	  This same cable can be used to flash new firmware.
 
+config SPI_DAVINCI
+	tristate "SPI controller driver for DaVinci/DA8xx SoC's"
+	depends on SPI_MASTER && ARCH_DAVINCI
+	select SPI_BITBANG
+	help
+	  SPI master controller for DaVinci and DA8xx SPI modules.
+
 config SPI_GPIO
 	tristate "GPIO-based bitbanging SPI Master"
 	depends on GENERIC_GPIO

drivers/spi/Makefile

@@ -16,6 +16,7 @@ obj-$(CONFIG_SPI_BFIN)			+= spi_bfin5xx.o
 obj-$(CONFIG_SPI_BITBANG)		+= spi_bitbang.o
 obj-$(CONFIG_SPI_AU1550)		+= au1550_spi.o
 obj-$(CONFIG_SPI_BUTTERFLY)		+= spi_butterfly.o
+obj-$(CONFIG_SPI_DAVINCI)		+= davinci_spi.o
 obj-$(CONFIG_SPI_DESIGNWARE)		+= dw_spi.o
 obj-$(CONFIG_SPI_DW_PCI)		+= dw_spi_pci.o
 obj-$(CONFIG_SPI_GPIO)			+= spi_gpio.o