Commit 35b675b9 authored by Richard Genoud's avatar Richard Genoud Committed by Greg Kroah-Hartman

tty/serial: at91: BUG: disable interrupts when !UART_ENABLE_MS()

In set_termios(), interrupts where not disabled if UART_ENABLE_MS() was
false.

Tested on at91sam9g35.
Signed-off-by: default avatarRichard Genoud <richard.genoud@gmail.com>
Cc: stable <stable@vger.kernel.org> # >= 3.16
Reviewed-by: default avatarPeter Hurley <peter@hurleysoftware.com>
Acked-by: default avatarNicolas Ferre <nicolas.ferre@atmel.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent f174442e
......@@ -526,6 +526,45 @@ static void atmel_enable_ms(struct uart_port *port)
UART_PUT_IER(port, ier);
}
/*
* Disable modem status interrupts
*/
static void atmel_disable_ms(struct uart_port *port)
{
struct atmel_uart_port *atmel_port = to_atmel_uart_port(port);
uint32_t idr = 0;
/*
* Interrupt should not be disabled twice
*/
if (!atmel_port->ms_irq_enabled)
return;
atmel_port->ms_irq_enabled = false;
if (atmel_port->gpio_irq[UART_GPIO_CTS] >= 0)
disable_irq(atmel_port->gpio_irq[UART_GPIO_CTS]);
else
idr |= ATMEL_US_CTSIC;
if (atmel_port->gpio_irq[UART_GPIO_DSR] >= 0)
disable_irq(atmel_port->gpio_irq[UART_GPIO_DSR]);
else
idr |= ATMEL_US_DSRIC;
if (atmel_port->gpio_irq[UART_GPIO_RI] >= 0)
disable_irq(atmel_port->gpio_irq[UART_GPIO_RI]);
else
idr |= ATMEL_US_RIIC;
if (atmel_port->gpio_irq[UART_GPIO_DCD] >= 0)
disable_irq(atmel_port->gpio_irq[UART_GPIO_DCD]);
else
idr |= ATMEL_US_DCDIC;
UART_PUT_IDR(port, idr);
}
/*
* Control the transmission of a break signal
*/
......@@ -1993,7 +2032,9 @@ static void atmel_set_termios(struct uart_port *port, struct ktermios *termios,
/* CTS flow-control and modem-status interrupts */
if (UART_ENABLE_MS(port, termios->c_cflag))
port->ops->enable_ms(port);
atmel_enable_ms(port);
else
atmel_disable_ms(port);
spin_unlock_irqrestore(&port->lock, flags);
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment