[PATCH] PCDP: call acpi_register_gsi() with arguments in correct order

PCDP: call acpi_register_gsi() with arguments in correct order
Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

drivers/firmware/pcdp.c

@@ -98,8 +98,8 @@ setup_serial_console(int rev, struct pcdp_uart *uart)
 
 	if (uart_irq_supported(rev, uart)) {
 		port.irq = acpi_register_gsi(uart->gsi,
-			uart_active_high_low(rev, uart),
-			uart_edge_level(rev, uart));
+			uart_edge_level(rev, uart),
+			uart_active_high_low(rev, uart));
 		port.flags |= UPF_AUTO_IRQ;  /* some FW reported wrong GSI */
 		if (uart_pci(rev, uart))
 			port.flags |= UPF_SHARE_IRQ;