Commit 374d968a authored by Eugen Hristev's avatar Eugen Hristev Committed by Mauro Carvalho Chehab

media: atmel: atmel-isc-base: initialize the try_crop for the pads in try_fmt

When requesting format from sensor, some sensors call the
subdev_get_try_crop which for ISC was not properly initialized, and this
causes errors in determining proper image resolutions.
To accommodate for this, when trying a format (in try_fmt), first attempt
to obtain the framesize for this format from sensor.
In case this fails, use the maximum ISC width/height as try_crop, otherwise
provide the first size height/width from the sensor.
Signed-off-by: default avatarEugen Hristev <eugen.hristev@microchip.com>
[hverkuil-cisco@xs4all.nl: changed {0} to {}]
Signed-off-by: default avatarHans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab+huawei@kernel.org>
parent da3a55b5
......@@ -1210,6 +1210,37 @@ static int isc_try_configure_pipeline(struct isc_device *isc)
return 0;
}
static void isc_try_fse(struct isc_device *isc,
struct v4l2_subdev_pad_config *pad_cfg)
{
int ret;
struct v4l2_subdev_frame_size_enum fse = {};
/*
* If we do not know yet which format the subdev is using, we cannot
* do anything.
*/
if (!isc->try_config.sd_format)
return;
fse.code = isc->try_config.sd_format->mbus_code;
fse.which = V4L2_SUBDEV_FORMAT_TRY;
ret = v4l2_subdev_call(isc->current_subdev->sd, pad, enum_frame_size,
pad_cfg, &fse);
/*
* Attempt to obtain format size from subdev. If not available,
* just use the maximum ISC can receive.
*/
if (ret) {
pad_cfg->try_crop.width = ISC_MAX_SUPPORT_WIDTH;
pad_cfg->try_crop.height = ISC_MAX_SUPPORT_HEIGHT;
} else {
pad_cfg->try_crop.width = fse.max_width;
pad_cfg->try_crop.height = fse.max_height;
}
}
static int isc_try_fmt(struct isc_device *isc, struct v4l2_format *f,
u32 *code)
{
......@@ -1313,6 +1344,9 @@ static int isc_try_fmt(struct isc_device *isc, struct v4l2_format *f,
if (ret)
goto isc_try_fmt_err;
/* Obtain frame sizes if possible to have crop requirements ready */
isc_try_fse(isc, &pad_cfg);
v4l2_fill_mbus_format(&format.format, pixfmt, mbus_code);
ret = v4l2_subdev_call(isc->current_subdev->sd, pad, set_fmt,
&pad_cfg, &format);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment