ARM: shmobile: Sync Lager DTS with Lager reference DTS

Copy the device nodes from Lager reference into the Lager device tree
file. This will allow us to use a single DTS file regarless of kernel
configuration. In case of legacy C board code the device nodes may or
may not be used, but in the multiplatform case all the DT device nodes
are used.
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>

arch/arm/boot/dts/r8a7790-lager.dts

@@ -10,6 +10,7 @@
 
 /dts-v1/;
 #include "r8a7790.dtsi"
+#include <dt-bindings/gpio/gpio.h>
 
 / {
 	model = "Lager";
@@ -33,4 +34,56 @@ lbsc {
 		#address-cells = <1>;
 		#size-cells = <1>;
 	};
+
+	leds {
+		compatible = "gpio-leds";
+		led6 {
+			gpios = <&gpio4 22 GPIO_ACTIVE_HIGH>;
+		};
+		led7 {
+			gpios = <&gpio4 23 GPIO_ACTIVE_HIGH>;
+		};
+		led8 {
+			gpios = <&gpio5 17 GPIO_ACTIVE_HIGH>;
+		};
+	};
+
+	fixedregulator3v3: fixedregulator@0 {
+		compatible = "regulator-fixed";
+		regulator-name = "fixed-3.3V";
+		regulator-min-microvolt = <3300000>;
+		regulator-max-microvolt = <3300000>;
+		regulator-boot-on;
+		regulator-always-on;
+	};
+};
+
+&pfc {
+	pinctrl-0 = <&scif0_pins &scif1_pins>;
+	pinctrl-names = "default";
+
+	scif0_pins: serial0 {
+		renesas,groups = "scif0_data";
+		renesas,function = "scif0";
+	};
+
+	scif1_pins: serial1 {
+		renesas,groups = "scif1_data";
+		renesas,function = "scif1";
+	};
+
+	mmc1_pins: mmc1 {
+		renesas,groups = "mmc1_data8", "mmc1_ctrl";
+		renesas,function = "mmc1";
+	};
+};
+
+&mmcif1 {
+	pinctrl-0 = <&mmc1_pins>;
+	pinctrl-names = "default";
+
+	vmmc-supply = <&fixedregulator3v3>;
+	bus-width = <8>;
+	non-removable;
+	status = "okay";
 };