Commit 3bdc9ba8 authored by Paul Walmsley's avatar Paul Walmsley Committed by Chris Ball

mmc: use really long write timeout to deal with crappy cards

Several people have noticed that crappy SD cards take much longer to
complete multiple block writes than the 300ms that Linux specifies.
Try to work around this by using a three second write timeout instead.

This is a generalized version of a patch from Chase Maupin
<Chase.Maupin@ti.com>, whose patch description said:

* With certain SD cards timeouts like the following have been seen
  due to an improper calculation of the dto value:
    mmcblk0: error -110 transferring data, sector 4126233, nr 8,
    card status 0xc00
* By removing the dto calculation and setting the timeout value
  to the maximum specified by the SD card specification part A2
  section 2.2.15 these timeouts can be avoided.
* This change has been used by beagleboard users as well as the
  Texas Instruments SDK without a negative impact.
* There are multiple discussion threads about this but the most
  relevant ones are:
    * http://talk.maemo.org/showthread.php?p=1000707#post1000707
    * http://www.mail-archive.com/linux-omap@vger.kernel.org/msg42213.html
* Original proposal for this fix was done by Sukumar Ghoral of
  Texas Instruments
* Tested using a Texas Instruments AM335x EVM
Signed-off-by: default avatarPaul Walmsley <paul@pwsan.com>
Tested-by: default avatarTony Lindgren <tony@atomide.com>
Signed-off-by: default avatarChris Ball <cjb@laptop.org>
parent 8c2fc8e4
......@@ -527,10 +527,14 @@ void mmc_set_data_timeout(struct mmc_data *data, const struct mmc_card *card)
if (data->flags & MMC_DATA_WRITE)
/*
* The limit is really 250 ms, but that is
* insufficient for some crappy cards.
* The MMC spec "It is strongly recommended
* for hosts to implement more than 500ms
* timeout value even if the card indicates
* the 250ms maximum busy length." Even the
* previous value of 300ms is known to be
* insufficient for some cards.
*/
limit_us = 300000;
limit_us = 3000000;
else
limit_us = 100000;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment