net: dsa: felix: clarify the intention of writes to MII_BMCR

The driver appears to write to BMCR_SPEED and BMCR_DUPLEX, fields which
are read-only, since they are actually configured through the
vendor-specific IF_MODE (0x14) register.

But the reason we're writing back the read-only values of MII_BMCR is to
alter these writable fields:

BMCR_RESET
BMCR_LOOPBACK
BMCR_ANENABLE
BMCR_PDOWN
BMCR_ISOLATE
BMCR_ANRESTART

In particular, the only field which is really relevant to this driver is
BMCR_ANENABLE. Clarify that intention by spelling it out, using
phy_set_bits and phy_clear_bits.

The driver also made a few writes to BMCR_RESET and BMCR_ANRESTART which
are unnecessary and may temporarily disrupt the link to the PHY. Remove
them.
Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/dsa/ocelot/felix_vsc9959.c

@@ -815,7 +815,7 @@ static void vsc9959_pcs_init_sgmii(struct phy_device *pcs,
 		phy_write(pcs, ENETC_PCS_LINK_TIMER2,
 			  ENETC_PCS_LINK_TIMER2_VAL);
 
-		phy_write(pcs, MII_BMCR, BMCR_ANRESTART | BMCR_ANENABLE);
+		phy_set_bits(pcs, MII_BMCR, BMCR_ANENABLE);
 	} else {
 		int speed;
 
@@ -845,10 +845,7 @@ static void vsc9959_pcs_init_sgmii(struct phy_device *pcs,
 			  ENETC_PCS_IF_MODE_SGMII_EN |
 			  ENETC_PCS_IF_MODE_SGMII_SPEED(speed));
 
-		/* Yes, not a mistake: speed is given by IF_MODE. */
-		phy_write(pcs, MII_BMCR, BMCR_RESET |
-					 BMCR_SPEED1000 |
-					 BMCR_FULLDPLX);
+		phy_clear_bits(pcs, MII_BMCR, BMCR_ANENABLE);
 	}
 }
 
@@ -882,9 +879,7 @@ static void vsc9959_pcs_init_2500basex(struct phy_device *pcs,
 		  ENETC_PCS_IF_MODE_SGMII_EN |
 		  ENETC_PCS_IF_MODE_SGMII_SPEED(ENETC_PCS_SPEED_2500));
 
-	phy_write(pcs, MII_BMCR, BMCR_SPEED1000 |
-				 BMCR_FULLDPLX |
-				 BMCR_RESET);
+	phy_clear_bits(pcs, MII_BMCR, BMCR_ANENABLE);
 }
 
 static void vsc9959_pcs_init_usxgmii(struct phy_device *pcs,