mfd: tps65090: add DT support for tps65090

Add device tree support for the TI PMIC TPS65090.
The device can be registered through platform or DT.

Add device tree binding document for this device.
Signed-off-by: Laxman Dewangan <ldewangan@nvidia.com>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>

Documentation/devicetree/bindings/regulator/tps65090.txt

+TPS65090 regulators
+
+Required properties:
+- compatible: "ti,tps65090"
+- reg: I2C slave address
+- interrupts: the interrupt outputs of the controller
+- regulators: A node that houses a sub-node for each regulator within the
+  device. Each sub-node is identified using the node's name, with valid
+  values listed below. The content of each sub-node is defined by the
+  standard binding for regulators; see regulator.txt.
+  dcdc[1-3], fet[1-7] and ldo[1-2] respectively.
+- vsys[1-3]-supply: The input supply for DCDC[1-3] respectively.
+- infet[1-7]-supply: The input supply for FET[1-7] respectively.
+- vsys-l[1-2]-supply: The input supply for LDO[1-2] respectively.
+
+Optional properties:
+- ti,enable-ext-control: This is applicable for DCDC1, DCDC2 and DCDC3.
+  If DCDCs are externally controlled then this property should be there.
+- "dcdc-ext-control-gpios: This is applicable for DCDC1, DCDC2 and DCDC3.
+  If DCDCs are externally controlled and if it is from GPIO then GPIO
+  number should be provided. If it is externally controlled and no GPIO
+  entry then driver will just configure this rails as external control
+  and will not provide any enable/disable APIs.
+
+Each regulator is defined using the standard binding for regulators.
+
+Example:
+
+	tps65090@48 {
+		compatible = "ti,tps65090";
+		reg = <0x48>;
+		interrupts = <0 88 0x4>;
+
+		vsys1-supply = <&some_reg>;
+		vsys2-supply = <&some_reg>;
+		vsys3-supply = <&some_reg>;
+		infet1-supply = <&some_reg>;
+		infet2-supply = <&some_reg>;
+		infet3-supply = <&some_reg>;
+		infet4-supply = <&some_reg>;
+		infet5-supply = <&some_reg>;
+		infet6-supply = <&some_reg>;
+		infet7-supply = <&some_reg>;
+		vsys_l1-supply = <&some_reg>;
+		vsys_l2-supply = <&some_reg>;
+
+		regulators {
+			dcdc1 {
+				regulator-name = "dcdc1";
+				regulator-boot-on;
+				regulator-always-on;
+				ti,enable-ext-control;
+				dcdc-ext-control-gpios = <&gpio 10 0>;
+			};
+
+			dcdc2 {
+				regulator-name = "dcdc2";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+
+			dcdc3 {
+				regulator-name = "dcdc3";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+
+			fet1 {
+				regulator-name = "fet1";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+
+			fet2 {
+				regulator-name = "fet2";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+
+			fet3 {
+				regulator-name = "fet3";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+
+			fet4 {
+				regulator-name = "fet4";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+
+			fet5 {
+				regulator-name = "fet5";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+
+			fet6 {
+				regulator-name = "fet6";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+
+			fet7 {
+				regulator-name = "fet7";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+
+			ldo1 {
+				regulator-name = "ldo1";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+
+			ldo2 {
+				regulator-name = "ldo2";
+				regulator-boot-on;
+				regulator-always-on;
+			};
+		};
+	};

drivers/mfd/tps65090.c

@@ -25,6 +25,8 @@
 #include <linux/i2c.h>
 #include <linux/mfd/core.h>
 #include <linux/mfd/tps65090.h>
+#include <linux/of.h>
+#include <linux/of_device.h>
 #include <linux/err.h>
 
 #define NUM_INT_REG 2
@@ -148,18 +150,31 @@ static const struct regmap_config tps65090_regmap_config = {
 	.volatile_reg = is_volatile_reg,
 };
 
+#ifdef CONFIG_OF
+static const struct of_device_id tps65090_of_match[] = {
+	{ .compatible = "ti,tps65090",},
+	{},
+};
+MODULE_DEVICE_TABLE(of, tps65090_of_match);
+#endif
+
 static int tps65090_i2c_probe(struct i2c_client *client,
 					const struct i2c_device_id *id)
 {
 	struct tps65090_platform_data *pdata = client->dev.platform_data;
+	int irq_base = 0;
 	struct tps65090 *tps65090;
 	int ret;
 
-	if (!pdata) {
-		dev_err(&client->dev, "tps65090 requires platform data\n");
+	if (!pdata && !client->dev.of_node) {
+		dev_err(&client->dev,
+			"tps65090 requires platform data or of_node\n");
 		return -EINVAL;
 	}
 
+	if (pdata)
+		irq_base = pdata->irq_base;
+
 	tps65090 = devm_kzalloc(&client->dev, sizeof(*tps65090), GFP_KERNEL);
 	if (!tps65090) {
 		dev_err(&client->dev, "mem alloc for tps65090 failed\n");
@@ -178,7 +193,7 @@ static int tps65090_i2c_probe(struct i2c_client *client,
 
 	if (client->irq) {
 		ret = regmap_add_irq_chip(tps65090->rmap, client->irq,
-			IRQF_ONESHOT | IRQF_TRIGGER_LOW, pdata->irq_base,
+			IRQF_ONESHOT | IRQF_TRIGGER_LOW, irq_base,
 			&tps65090_irq_chip, &tps65090->irq_data);
 			if (ret) {
 				dev_err(&client->dev,
@@ -247,6 +262,7 @@ static struct i2c_driver tps65090_driver = {
 	.driver	= {
 		.name	= "tps65090",
 		.owner	= THIS_MODULE,
+		.of_match_table = of_match_ptr(tps65090_of_match),
 		.pm	= &tps65090_pm_ops,
 	},
 	.probe		= tps65090_i2c_probe,