Commit 41655239 authored by Daniel Thompson's avatar Daniel Thompson Committed by Stephen Boyd

dt-bindings: Document the STM32F4 clock bindings

This adds documentation of device tree bindings for the clock related
portions of the STM32 RCC block.
Signed-off-by: default avatarDaniel Thompson <daniel.thompson@linaro.org>
Acked-by: default avatarMaxime Coquelin <maxime.coquelin@st.com>
Signed-off-by: default avatarStephen Boyd <sboyd@codeaurora.org>
parent 2cd7b043
STMicroelectronics STM32 Reset and Clock Controller
===================================================
The RCC IP is both a reset and a clock controller. This documentation only
describes the clock part.
Please also refer to clock-bindings.txt in this directory for common clock
controller binding usage.
Required properties:
- compatible: Should be "st,stm32f42xx-rcc"
- reg: should be register base and length as documented in the
datasheet
- #clock-cells: 2, device nodes should specify the clock in their "clocks"
property, containing a phandle to the clock device node, an index selecting
between gated clocks and other clocks and an index specifying the clock to
use.
Example:
rcc: rcc@40023800 {
#clock-cells = <2>
compatible = "st,stm32f42xx-rcc", "st,stm32-rcc";
reg = <0x40023800 0x400>;
};
Specifying gated clocks
=======================
The primary index must be set to 0.
The secondary index is the bit number within the RCC register bank, starting
from the first RCC clock enable register (RCC_AHB1ENR, address offset 0x30).
It is calculated as: index = register_offset / 4 * 32 + bit_offset.
Where bit_offset is the bit offset within the register (LSB is 0, MSB is 31).
Example:
/* Gated clock, AHB1 bit 0 (GPIOA) */
... {
clocks = <&rcc 0 0>
};
/* Gated clock, AHB2 bit 4 (CRYP) */
... {
clocks = <&rcc 0 36>
};
Specifying other clocks
=======================
The primary index must be set to 1.
The secondary index is bound with the following magic numbers:
0 SYSTICK
1 FCLK
Example:
/* Misc clock, FCLK */
... {
clocks = <&rcc 1 1>
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment