Merge tag 'hwmon-for-v5.13-rc6' of...

Merge tag 'hwmon-for-v5.13-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/groeck/linux-staging

Pull hwmon fixes from Guenter Roeck:
 "Fixes for tps23861, scpi-hwmon, and corsair-psu drivers, plus a
  bindings fix for TI ADS7828"

* tag 'hwmon-for-v5.13-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/groeck/linux-staging:
  hwmon: (tps23861) correct shunt LSB values
  hwmon: (tps23861) set current shunt value
  hwmon: (tps23861) define regmap max register
  hwmon: (scpi-hwmon) shows the negative temperature properly
  hwmon: (corsair-psu) fix suspend behavior
  dt-bindings: hwmon: Fix typo in TI ADS7828 bindings

Documentation/devicetree/bindings/hwmon/ti,ads7828.yaml

@@ -49,7 +49,7 @@ examples:
         #size-cells = <0>;
 
         adc@48 {
-            comatible = "ti,ads7828";
+            compatible = "ti,ads7828";
             reg = <0x48>;
             vref-supply = <&vref>;
             ti,differential-input;

drivers/hwmon/corsair-psu.c

@@ -771,6 +771,16 @@ static int corsairpsu_raw_event(struct hid_device *hdev, struct hid_report *repo
 	return 0;
 }
 
+#ifdef CONFIG_PM
+static int corsairpsu_resume(struct hid_device *hdev)
+{
+	struct corsairpsu_data *priv = hid_get_drvdata(hdev);
+
+	/* some PSUs turn off the microcontroller during standby, so a reinit is required */
+	return corsairpsu_init(priv);
+}
+#endif
+
 static const struct hid_device_id corsairpsu_idtable[] = {
 	{ HID_USB_DEVICE(0x1b1c, 0x1c03) }, /* Corsair HX550i */
 	{ HID_USB_DEVICE(0x1b1c, 0x1c04) }, /* Corsair HX650i */
@@ -793,6 +803,10 @@ static struct hid_driver corsairpsu_driver = {
 	.probe		= corsairpsu_probe,
 	.remove		= corsairpsu_remove,
 	.raw_event	= corsairpsu_raw_event,
+#ifdef CONFIG_PM
+	.resume		= corsairpsu_resume,
+	.reset_resume	= corsairpsu_resume,
+#endif
 };
 module_hid_driver(corsairpsu_driver);
 

drivers/hwmon/scpi-hwmon.c

@@ -99,6 +99,15 @@ scpi_show_sensor(struct device *dev, struct device_attribute *attr, char *buf)
 
 	scpi_scale_reading(&value, sensor);
 
+	/*
+	 * Temperature sensor values are treated as signed values based on
+	 * observation even though that is not explicitly specified, and
+	 * because an unsigned u64 temperature does not really make practical
+	 * sense especially when the temperature is below zero degrees Celsius.
+	 */
+	if (sensor->info.class == TEMPERATURE)
+		return sprintf(buf, "%lld\n", (s64)value);
+
 	return sprintf(buf, "%llu\n", value);
 }
 

drivers/hwmon/tps23861.c

@@ -99,11 +99,14 @@
 #define POWER_ENABLE			0x19
 #define TPS23861_NUM_PORTS		4
 
+#define TPS23861_GENERAL_MASK_1		0x17
+#define TPS23861_CURRENT_SHUNT_MASK	BIT(0)
+
 #define TEMPERATURE_LSB			652 /* 0.652 degrees Celsius */
 #define VOLTAGE_LSB			3662 /* 3.662 mV */
 #define SHUNT_RESISTOR_DEFAULT		255000 /* 255 mOhm */
-#define CURRENT_LSB_255			62260 /* 62.260 uA */
-#define CURRENT_LSB_250			61039 /* 61.039 uA */
+#define CURRENT_LSB_250			62260 /* 62.260 uA */
+#define CURRENT_LSB_255			61039 /* 61.039 uA */
 #define RESISTANCE_LSB			110966 /* 11.0966 Ohm*/
 #define RESISTANCE_LSB_LOW		157216 /* 15.7216 Ohm*/
 
@@ -117,6 +120,7 @@ struct tps23861_data {
 static struct regmap_config tps23861_regmap_config = {
 	.reg_bits = 8,
 	.val_bits = 8,
+	.max_register = 0x6f,
 };
 
 static int tps23861_read_temp(struct tps23861_data *data, long *val)
@@ -560,6 +564,15 @@ static int tps23861_probe(struct i2c_client *client)
 	else
 		data->shunt_resistor = SHUNT_RESISTOR_DEFAULT;
 
+	if (data->shunt_resistor == SHUNT_RESISTOR_DEFAULT)
+		regmap_clear_bits(data->regmap,
+				  TPS23861_GENERAL_MASK_1,
+				  TPS23861_CURRENT_SHUNT_MASK);
+	else
+		regmap_set_bits(data->regmap,
+				TPS23861_GENERAL_MASK_1,
+				TPS23861_CURRENT_SHUNT_MASK);
+
 	hwmon_dev = devm_hwmon_device_register_with_info(dev, client->name,
 							 data, &tps23861_chip_info,
 							 NULL);