rtw88: unify prefixes for tx power setting routine

Rename the function names to make them have the same prefix "rtw_phy"
for the tx power setting routines. Only the function names and
corresponding identation are modified.
Signed-off-by: Yan-Hsuan Chuang <yhchuang@realtek.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/realtek/rtw88/main.c

@@ -1047,7 +1047,7 @@ static int rtw_chip_board_info_setup(struct rtw_dev *rtwdev)
 
 	rtw_phy_setup_phy_cond(rtwdev, 0);
 
-	rtw_hw_init_tx_power(hal);
+	rtw_phy_init_tx_power(hal);
 	rtw_load_table(rtwdev, rfe_def->phy_pg_tbl);
 	rtw_load_table(rtwdev, rfe_def->txpwr_lmt_tbl);
 	rtw_phy_tx_power_by_rate_config(hal);

drivers/net/wireless/realtek/rtw88/phy.h

@@ -41,7 +41,7 @@ void rtw_phy_cfg_bb(struct rtw_dev *rtwdev, const struct rtw_table *tbl,
 		    u32 addr, u32 data);
 void rtw_phy_cfg_rf(struct rtw_dev *rtwdev, const struct rtw_table *tbl,
 		    u32 addr, u32 data);
-void rtw_hw_init_tx_power(struct rtw_hal *hal);
+void rtw_phy_init_tx_power(struct rtw_hal *hal);
 void rtw_phy_load_tables(struct rtw_dev *rtwdev);
 void rtw_phy_set_tx_power_level(struct rtw_dev *rtwdev, u8 channel);
 void rtw_phy_tx_power_by_rate_config(struct rtw_hal *hal);