Revert "wcn36xx: Enable firmware link monitoring"

Firmware link offload monitoring can be made to work in 3/4 cases by
switching on firmware feature bit WLANACTIVE_OFFLOAD

- Secure power-save on
- Secure power-save off
- Open power-save on

However, with an open AP if we switch off power-saving - thus never
entering Beacon Mode Power Save - BMPS, firmware never forwards loss
of beacon upwards.

We had hoped that WLANACTIVE_OFFLOAD and some fixes for sequence numbers
would unblock this but, it hasn't and further investigation is required.

Its possible to have a complete set of Secure power-save on/off and Open
power-save on/off provided we use Linux' link monitoring mechanism.

While we debug the Open AP failure we need to fix upstream.

This reverts commit c973fdad79f6eaf247d48b5fc77733e989eb01e1.
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
Link: https://lore.kernel.org/r/20211025093037.3966022-2-bryan.odonoghue@linaro.org

drivers/net/wireless/ath/wcn36xx/main.c

@@ -1350,7 +1350,6 @@ static int wcn36xx_init_ieee80211(struct wcn36xx *wcn)
 	ieee80211_hw_set(wcn->hw, HAS_RATE_CONTROL);
 	ieee80211_hw_set(wcn->hw, SINGLE_SCAN_ON_ALL_BANDS);
 	ieee80211_hw_set(wcn->hw, REPORTS_TX_ACK_STATUS);
-	ieee80211_hw_set(wcn->hw, CONNECTION_MONITOR);
 
 	wcn->hw->wiphy->interface_modes = BIT(NL80211_IFTYPE_STATION) |
 		BIT(NL80211_IFTYPE_AP) |