arm64: dts: meson: Enable active coling using gpio-fan on Odroid N2/N2+

Odroid N2/N2+ support active cooling via gpio-fan controller.
Add fan controls and tip point for cpu and ddr thermal sensor
on this boards.
Signed-off-by: Anand Moon <linux.amoon@gmail.com>
Link: https://lore.kernel.org/r/20221021050906.1158-1-linux.amoon@gmail.comSigned-off-by: Neil Armstrong <neil.armstrong@linaro.org>

arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi

@@ -39,6 +39,14 @@ emmc_pwrseq: emmc-pwrseq {
 		reset-gpios = <&gpio BOOT_12 GPIO_ACTIVE_LOW>;
 	};
 
+	fan: gpio-fan {
+		compatible = "gpio-fan";
+		gpios = <&gpio_ao GPIOAO_10 GPIO_ACTIVE_HIGH>;
+		/* Using Dummy Speed */
+		gpio-fan,speed-map = <0 0>, <1 1>;
+		#cooling-cells = <2>;
+	};
+
 	leds {
 		compatible = "gpio-leds";
 
@@ -410,6 +418,40 @@ &cpu103 {
 	clock-latency = <50000>;
 };
 
+&cpu_thermal {
+	trips {
+		cpu_active: cpu-active {
+			temperature = <60000>; /* millicelsius */
+			hysteresis = <2000>; /* millicelsius */
+			type = "active";
+		};
+	};
+
+	cooling-maps {
+		map {
+			trip = <&cpu_active>;
+			cooling-device = <&fan THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
+		};
+	};
+};
+
+&ddr_thermal {
+	trips {
+		ddr_active: ddr-active {
+			temperature = <60000>; /* millicelsius */
+			hysteresis = <2000>; /* millicelsius */
+			type = "active";
+		};
+	};
+
+	cooling-maps {
+		map {
+			trip = <&ddr_active>;
+			cooling-device = <&fan THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
+		};
+	};
+};
+
 &ext_mdio {
 	external_phy: ethernet-phy@0 {
 		/* Realtek RTL8211F (0x001cc916) */